Tandberg Data 600 manual Confirming the Installation

SDLT 600 Product Manual Chapter 4: Installing Your Tape Drive

The tabletop unit power supply has an auto-sensing feature; it requires no adjustment or switch setting changes for different AC sources.

Refer to Figure 4-9and Figure 4-12. Connect one end of the AC cord into the power connector on the back of the tabletop tape drive; connect the other end of the cord to the AC outlet. Upon completion, proceed to the next section to confirm the installation.

4.7Confirming the Installation

To confirm the installation, power on the SDLT 600 tape drive system and the host computer. The screens displayed at power-on contain BIOS, operating system, and SCSI controller information. If the first screen displays host adapter and SCSI ID information, then the installation is successful. Refer to “Troubleshooting” on page 5-12if the installation is not successful.

81-81184-02 REV A01 March 2004 4-25