Tandberg Data 600 B.2 Data Cartridge Inspection Procedure, Appendix B DLTtape VS1 Data Cartridge

SDLT 600 Product Manual Appendix B: DLTtape VS1 Data Cartridge

B.2 Data Cartridge Inspection Procedure

Ensure your data cartridge backup solution performs reliably by following the Visual Mechanical Inspection (VMI) procedures described in this subsection. These steps help you identify any potential data cartridge problems, and prevent accidental loss of data or damage to your SDLT 600 tape drive system.

You should do an inspection if any of these conditions occur:

•As a general practice whenever you change or load a new data cartridge.

•If a data cartridge is dropped or subjected to some hard physical shock.

•If the SDLT 600 tape drive becomes inoperable after loading a data cartridge.

•If you receive a shipment of data cartridges that show any sign of shipping damage.

Follow these steps to visually inspect a DLTtape VS1 data cartridge:

1.Remove the data cartridge from its protective plastic case.

2.Gently shake the data cartridge. Listen for any rattling or sounds of any loose pieces inside the data cartridge. If you hear anything loose inside, do not use the data cartridge.

3.Check the data cartridge for any obvious cracks or other physical damage to the shell. Rotate the data cartridge in your hands, looking for broken or missing parts.

4.Grasp the data cartridge to view the bottom as shown in Figure B-1. (The media access door is on the top edge and the write protect switches are on the bottom edge.)

Spring-loaded Hub

Reel Lock

Figure B-1.Bottom View of DLTtape VS1 Data Cartridge

81-81184-02 REV A01 March 2004 B-3