Tektronix Phaser 840 setup guide Setting IPX frame types from the front panel

4 Novell NetWare Configuration

Verify information and finish the configuration

After you have entered the configuration information, the Quick Configuration Wizard displays the Configured Printer Information dialog box, which reports the information you have entered.

1.Verify that the information is correct.

■If the information is correct, click Apply Changes.

■If the information is not correct, click Back to return to previous dialog boxes and correct the information. Click Next to return to the Configured Printer Information dialog box. Click Apply Changes.

■To exit the wizard and return to the Main window without making any changes, click Cancel.

2.After you click Apply Changes, the printer resets; the changes take effect when the reset is complete.

3.After the reset, you are prompted to print a test page. It is recommended that you print a test page to verify a successful installation. For more information on NetWare configuration and troubleshooting, see the PhaserShare Networking Manual on your printer’s CD-ROM.

Setting IPX frame types from the front panel

1.When the front panel displays READY TO PRINT, press the down-arrow button until Menu is highlighted. Press Select.

2.Press the down-arrow button until Printer Configuration is highlighted. Press Select.

3.Press the down-arrow button until Network Settings is highlighted. Press Select.

4.Press the down-arrow button until NetWare is highlighted. Press Select.

5.Press the down-arrow button until IPX Frame Type is highlighted. Press Select.

6.Press the down-arrow button until the desired frame type is highlighted. Press Select until On is displayed. If desired, you can set more than one frame type.

7.To return the printer to normal operation, press the down-arrow button until Exit is highlighted. Press Select.

24PhaserShare Networking