Crosspatch Setup Window

Local Setup

Enable Line – Line Check Box

The Enable Line – Line check box indicates whether or not audio can be routed from one line to another line. If selected, audio is routed from one line to the other line. TX traffic from the console overrides the crosspatch to allow the console operator to take control of the line.

Start Patch FTone Drop Down Menu

NOTE: When using the Start and Stop FTone, the Line-Line check box must NOT be selected.

The Start Patch FTone drop down menu identifies the Ethernet function tone selection that starts a crosspatch between line 1 and line 2.

Stop Patch FTone Drop Down Menu

The Stop Patch FTone drop down menu identifies Ethernet function tone selection that stops a crosspatch between line 1 and line 2.

Remote Setup

RCP Enable Check Box

The RCP Enable check box indicates whether or not RCP (Remote Crosspatch) is enabled. If selected, RCP is enabled.

Dialing Digits Field

The Dialing Digits field identifies the number of DTMF (Dual Tone Multi-Frequency) digits allowed in the Drop All, Add String, and Delete String fields on the window.

The entry can be 2, 3, or 4.

Interdigit Time Field

The Interdigit Time field identifies the amount of time, in ms, allowed between DTMF digits before a reset occurs. If a reset occurs, the DTMF sequence must be started again.

This range for this field is 0 to 32000ms

Beep Dly Field

The Beep Dly field identifies the amount of time, in ms, between the digit string detection and status beeps echoed back to the hand-held radio.

The range for this field is 0 to 5000ms.

103

Page 101
Image 101
Telex IP-223 technical manual 103