Local/Radio Connections

TX Audio Connection

The IP-223 has a number of options when connecting to the radio. Different jumper settings are required for different revisions of the PCB installed in the IP-223 unit, and are noted below. Set the jumper position listed for the line according to the connection type shown below.

If the radio transmit audio output is balanced,

connect to pins 13 and 25 of the DB25 connector.

If the transmit audio is single ended,

use pin 25 of the DB25 connector.

NOTE: Shielded cable is recommended.

PCB 750743 or PCB 750630 revision C and higher

Line 1 jumpers: J3, J9, and J11

Line 2 jumpers: J25, J28, and J29

Jumper Position Connection Type

ASingle Ended Low-Impedence

BBalanced 600 ohm

RX Audio Connection

To connect the radio receiver audio to the IP-223, different jumper settings are required for different revisions of the PCB installed in the IP-223 unit, and are noted below. Set the jumper position for the line according to the connection type shown below.

If the radio receiver audio output is balanced, connect to pins 12 and 24 of the DB25 connector.

If the receiver audio is single ended, use pin 24 of the DB25 connector. The audio source must be after the squelch circuit to prevent sending continuous noise to the remote console.

If a high-impedance point in the receiver is used, a shielded cable is recommended.

PCB 750743 or PCB 750630 revision C and higher

Line 1 jumpers: J16 and J21

Line 2 jumpers: J19 and J20

Jumper Position Connection Type

ASingle Ended Low-Impedence

BBalanced 600 ohm

27

Page 25
Image 25
Telex IP-223 technical manual TX Audio Connection, RX Audio Connection, Line 1 jumpers J3, J9, and J11