
Overview
•When connected to a serially controlled radio, iDEN, Sepura, Kenwood or Johnson displays.
•INTCOM displays when the front panel IC button is pressed.
•EnetIC displays when the console generated intercom is received.
•CTX F# displays when the console mode
•CRX F# displays when the
•PTX F# displays when the
•CPT F# displays when the
•Ring displays when there is an incoming phone call in Phone mode.
•Offhook displays when the line is in use during a phone call.
•LLM displays when no phone line is connected to the PIB or TDI in Phone mode.
•NO LINE ENABLED displays after
•Scan List.... displays during power up while the
To toggle the LCD display, do the following:
1.Press and hold the line button and then momentarily press the IC button. Three different displays are available with each press of the IC button:
•While pressing the line button, press the IC button once. The IP Address and Mask Address of the unit displays.
•Continue to hold the line button, then press the IC button a second time. The TX alignment tones are turned ON.
•Continue to hold the line button, then press the IC button a third time. The RX VU meter displays.
2.Press the IC button a fourth time to clear the display and return to the normal LCD display.
3.Release the line button.
Line Button
The Line button is used to select which radio, or line, the handset audio is routed and which line is being monitored. The handset line selection is displayed as an asterisk (*) in the right most column of the LCD display. An asterisk (*) on the top line of the display indicates a connection to line 1, and an asterisk (*) on the bottom line of the display indicates a connection to line 2.
TX LED
The TX LED provides a visual indication the
LNK LED
The LNK LED provides a visual indication of the Ethernet connection. When the LED is illuminated, a valid network connection is established.
18