Telex Save to Eeprom Window, Save Parameters Button, Reset IP-223 Button, Click Reset IP-223

Setup Information

Save to EEPROM Window

The Save to EEPROM window is used to save the current configuration to the IP-223 or to reset the parameters on the configuration webpage to the last configuration saved to the IP-223.

NAVIGATION: Clicking Save to EEPROM displays the Save Parameters and Reset IP-223 command buttons, shown in Figure 119

FIGURE 119. Save to EEPROM

Save Parameters Button

The Save Parameters button is used to save any changes submitted to the IP-223 for storage into permanent memory.

Reset IP-223 Button

The Reset IP-223button is used to perform a full reset of the IP-223. This is the software version of a power down reset.

To save changes to permanent memory, do the following:

1.From the links, select Save to EEPROM. The Save Setup Parameters window appears.

2.Click Save Parameters.

The parameters are saved to permanent memory.

NOTE: If the Submit button on an individual setup window was not selected before moving to another window, any changes made to the entries on the window are not saved to permanent memory even when the Save Parameters Button is selected.

To reset the IP-223, do the following:

1.From the links, select Save to EEPROM. The Save Setup Parameters window appears.

2.Click Reset IP-223.

A momentary loss of connectivity occurs and the window shown in Figure 120 appears. The connection is restored after several seconds.

3.Click a link to access a setup window, otherwise close the web browser.

90