Installation and Level Settings

 

Jumper Position

 

 

 

 

Line 1

Line 2

 

 

 

Receive Input Impedance:

J14

J24

 

 

 

8 ohms (for a speaker input)

B

B

 

 

 

600 ohm

A

A

 

 

 

10k ohm

NULL

NULL

 

 

 

NOTE: When the speaker output is used, the radio volume control affects the audio levels of the IP-223.

 

 

 

Jumper Position

 

 

 

 

 

 

 

 

 

Line 1

 

 

Line 2

 

 

 

 

 

 

Receive Input Impedance:

J14

 

J23

J17

 

J24

 

 

 

 

 

 

 

8 ohms (for a speaker input)

B

 

A

A

 

B

 

 

 

 

 

 

 

600 ohm

A

 

B

B

 

A

 

 

 

 

 

 

 

10k ohm

B

 

B

B

 

B

 

 

 

 

 

 

 

COR (Carrier Operated Relay) I/O (Input/Output)

The COR I/O connection indicates that audio is being received from the radio. The COR connection is provided at DIG6, pin 20 of the DB25 connector.

PTT Connection

Connect the radio PTT circuit to the PTT relay contact terminals on the DB25 connector. Usually the common of the relay contact switch is grounded and the normally open contact connects to the PTT input. An alternative method to ground the common of the relay internal to the unit is to jumper R377 (line 1) and R381 (line 2) with a piece of wire soldered closed.

Monitor Connection

Connect the radio MON circuit to the MON relay contact terminals on the DB25 connector. Usually the common of each relay contact switch is grounded and the normally open contact connects to the MON input. An alternative method to ground the common of the relay internal to the unit is to jumper R376 (line 1) and R380 (line 2) with a piece of wire soldered closed.

R1 and R2 Relays

The IP-223 provides two (2) relay closures for controlling the frequency of the radio, or switching a remote ancillary device. The F1 and F2 contacts can be connected through the DB25 connector. Usually the common of each relay contact switch is grounded and the normally open contact connects to the radio frequency control terminals. Information on programming the R1 and R2 relays is provided in the “Setup Information” chapter of this manual starting on page 33. An alternative method to ground the common of the relay R1 internal to the unit is to jumper R375 (line 1) and R379 (line 2), and for relay R2 jumper R374 (line 1) and R378 (line 2) with a piece of wire soldered closed.

28

Page 26
Image 26
Telex IP-223 COR Carrier Operated Relay I/O Input/Output, PTT Connection, Monitor Connection, R1 and R2 Relays