Setup Information

Select one of the following operating modes for the monitor relay:

Reset with PTT – When selected, the monitor relay is closed from the time the monitor tone sequence is received until the next PTT operation.

On except PTT – When selected, the monitor relay is latched at all times except when PTT is active, whether the monitor function tone is received or not.

Timed –

When selected, enter the amount of time, in ms, the monitor relay is latched.

Options

If an Options field cannot be selected, the particular option is not available for the line number to which the details on the window apply.

Full Duplex Check Box

The Full Duplex check box indicates whether or not full duplex Ethernet is supported. If selected, full duplex (TX and RX transmission) audio packets are allowed.

RxAGC Check Box

The RxAGC (Automatic Gain Control) check box indicates whether or not the radio RX audio includes an AGC. If selected, an AGC step is added to the radio RX audio. This results in the transmission of a more consistent radio RX audio by increasing the level of low audio and decreasing the level of loud audio.

Hi-Pass RX Check Box

The Hi-Pass RX check box indicates whether or not RX audio below 300Hz is blocked. If selected, RX audio below 300Hz is blocked.

Pre-Emphasize TX Check Box

The Pre-Emphasize TX check box indicates whether or not TX audio includes a standard 6dB octave pre-emphasis. If selected, a standard 6dB octave pre-emphasis is included in the TX audio.

F1 Last Call Check Box (iDEN Mode only)

The F1 Last Call check box indicates whether or not the last call is reserved for the F1 button. If selected, function tone 1 is reserved for the last call. This allows the console operator to call back the last call received.

PTT Notch Filter Check Box

The PTT Notch Filter checkbox, when selected, indicates the 2175Hz notch filter is bypassed. When selected, 2175Hz ±180Hz frequency range is ignored during PTT. Use this option when 2175Hz is blocking desirable audio.

Busy Channel Lockout Check Box

The Busy Channel Lockout check box indicates outgoing FleetSync messages are placed in queue until the radio is idle. FleetSync messages can be lost when sent on half-duplex radios. Selecting this check box avoids lost messages.

PTT Setup

The PTT Setup section allows a secondary external function to be controlled with a separate relay closure at the same time as the PTT relay. Select one of the following:

PTT relay only – When selected, only the PTT relay is closed. (Default Setting)

82

Page 80
Image 80
Telex IP-223 technical manual Full Duplex Check Box, F1 Last Call Check Box iDEN Mode only