Setup Information
To configure the IP-223 for use, do the following:
1.From the links, select Basic Ethernet Setup. The Basic Ethernet Setup window appears.
2.In the Unit IP Address field, enter the IP Address.
3.In the Subnet Mask field, enter the subnet mask address.
4.In the Gateway Address field, enter the gateway address, if required.
5.In the Unit Name field, enter a descriptive name.
6.In the Packet Delay before Playback field, enter the number of packets of delay for playback (each packet is 20ms of audio).
7.In the QOS: Precendence Bits field, enter the number of bits, if required.
8.In the QOS: D, T, and R Bits field, enter the number of bits, if required.
9.In the Local Computer IP Address fields, enter the IP Addresses of the
10.Click Submit.
The entries currently displayed on the window are sent to the
11.From the links, select Save to EEPROM. The Save Setup Parameters window appears.
12.Click Save Parameters.
The entries are saved to permanent memory.
Submit Button
The Submit button, located at the bottom of each configuration window, is used to upload changes to the
IMPORTANT: The submit button saves changes in temporary memory only.
To permanently save changes, do the following:
1.Click Submit. 
The changes are sent to the
2.Click Save to EEPROM. 
The Save to EEPROM window opens.
3.Click Save Parameters. 
Changes are now permanently saved to the
46
