Initial Configuration
If you have not already done so, connect the PC to the SMS2000 subscriber port, by plugging one end of a
Note: If you are not using a hub to connect to the subscriber port, you must use a crossover cable.
To connect using a hub:
5.Plug one end of a
6.Plug one end of another Ethernet cable into the subscriber port on the back of the SMS2000 and the other into the hub.
7.Ensure the hub is not connected to any other network.
Note: Do not plug the subscriber port of the SMS2000 into your network.
Isolate the PC and SMS2000 from the rest of your network.
Perform the following steps to gain access to an unconfigured SMS2000:
1.From the Windows task bar, click Start.
2.From the Start menu, select Run.
3.In the Run dialog box, enter Telnet.
4.Click OK.
5.Click Connect and select Remote System. The Connect dialog box displays.
6.Enter 35.42.42.42 for the host name.
Note: 35.42.42.42 is the internal factory default IP address for the SMS2000. Once you configure the IP address on your SMS2000, use the IP address that you have assigned instead.
7.Enter 4242 for the port number.
8.Select vt100 for the TermType.
9.Click Connect.
At this point you will be presented with the logon prompt.
10.Log on using the login name “manager” and password “manager.”
Note: The password “manager” is the default password for the SMS2000. You are strongly encouraged to change your initial logon password as soon as possible to ensure security.
Once you have successfully logged on to the SMS2000, you can proceed with the basic configuration of your system.
TUT Systems, Inc | Page 21 of 104 | P/N |
