Tut Systems SMS2000 manual Defining Ports, Setting and Deleting Static Ports, Leftrighthelp ?

System Administration

{leftright}}[help ?]

For example, with system linetest on and the SMS2000 rebooted, the SMS2000 generates a broadcast to the subscriber Ethernet interface once per second. Installers should check for a blinking LED on a Long Run or Home Run adapter if they do not have diagnostic equipment.

sms2000% system linetest on

For example, to cause a test print page to be sent to the configured LPR printer, use:

sms2000% system lprtest

Note: Some of the system command options will disrupt elements of the current configuration. For more information on the use of the system command and its’ options, see the SMS2000 Command Reference.

Defining Ports

Note: Altering this setting is normally not necessary, even when using VLAN switches in conjunction with Expresso GS/MDU Chassis or MDU Lites.

To configure the type of addressing information used by the SMS2000 to identify unique subscriber ports, use this command:

port-definition {mixed tut vlan}

For example, to configure SMS2000 to ignore VLAN tags and focus exclusively on SNMP information, which is useful in error situations where addressing information fails when a subscriber is connected bymeans of an Expresso GS/MDU Chassis behind a VLAN switch, type:

sms2000% port-definition tut

Setting and Deleting Static Ports

Use the set port command to specify port types for all ports, and to set a port or a range of ports as static, dynamic, or disabled or to delete ports.

For static ports, this command can also configure an IP address, local route, and default VLAN ID. When you configure a single static port, you can use an optional IP address and subnet mask to automatically configure the interface and add a local route. If a subnet mask is not specified, the default 255.255.255.255 is used.

Note: When using multiple MDU Lites behind a VLAN switch, such as a Cisco Catalyst switch where most ports can have only one non-default VLAN ID, make sure to specify the VLAN ID of each MDU Lite when configuring its static port. After configuration is complete, verify that it is working. First, reboot the SMS2000, VLAN Switch, and MDU Lites. Then, "snmp-poll 000000000000". If the SMS2000 should correctly ARP for each MDU Lite on its configured default VLAN, and immediately SNMP poll it, the command will return promptly. If this test fails, check the VLAN configuration.

TUT Systems, Inc Page 34 of 104 P/N 220-06288-20