Delta Electronics 115V Series, 230V Series, 460V Series manual Explanation Settings Factory

Chapter 5 ParametersVFD-S Series

Pr.	Explanation	Settings	Factory	NOTE
			Setting
6-05	Over-Torque Detection Time	d0.1 to d10.0 Sec	d0.1
6-06	Electronic Thermal Overload Relay	d0 to d2	d2
	Selection
6-07	Electronic Thermal	d30 to d600 Sec	d60
	Characteristic
6-08	Present Fault Record	d0: No fault
		d1: Over current (oc)
		d2: Over voltage (ov)
		d3: Over heat (oH)
		d4: Over load (oL)
6-09	Second Most Recent Fault Record	d5: Over load (oL1)
		d6: External fault (EF)
		d7: Reserved	d0
		d8: Reserved
		d9: Excess current during
		acceleration (ocA)
6-10	Third Most Recent Fault Record	d10: Excess current during
		deceleration (ocd)
		d11: Excess current during steady
		state (ocn)
		d12: Ground fault (GF)
		d13: Reserved
		d14: Low voltage (Lv)
		d15: CPU failure 1 (cF1)
		d16: CPU failure 2 (cF2)
		d17: Base block (b.b.)
		d18: Overload (oL2)
		d19: Auto acceleration/deceleration
		failure (cFA)
		d20: Software protection enable
		(codE)
		d21: Reserved
		d22: CPU failure (cF3.1)
		d23: CPU failure (cF3.2)
		d24: CPU failure (cF3.3)
		d25: CPU failure (cF3.4)
		d26: CPU failure (cF3.5)
		d27: CPU failure (cF3.6)
		d28: CPU failure (cF3.7)
		d29: Hardware protection failure
		(HPF.1)
		d30: Hardware protection failure
		(HPF.2)
		d31: Hardware protection failure
		(HPF.3)
		d32: Communication time-out
		(CE10)
		d33: Reserved
		d34: Software error (SErr)
		d35: Reserved
		d36: PID error (Pld)	d0
		d37: Reserved
		d38: Phase loss (PHL)

5-8 Revision August 2006, SE08, SW V2.61