Delta Electronics 460V Series, 230V Series, 115V Series manual Command

Chapter 5 ParametersVFD-S Series

The JOG function can be selected using Multi-function Input terminals (Pr.4-04 to Pr.4-08) if

programmed for Jog (d10). When the Jog terminal is “closed”, the AC drive will accelerate

from Minimum Output Frequency (Pr.1-05) to Jog Frequency (Pr.1-14). When the Jog

terminal “open”, the AC drive will decelerate from Jog Frequency to zero. The

acceleration/deceleration time is decided by the Jog acceleration/deceleration time (Pr.1-13).

During operation, the AC drive cannot perform Jog command. And during Jog operation,

other operation commands cannot be accepted, except command of FORWARD, REVERSE

and STOP keys on the digital keypad.

Frequency

Max.

Output freq. Pr.1-00

Jog

Freq.

Pr.1-14

Time

		Pr. 1-13			Pr. 1-13
	Acceleration Time			Deceleration Time
Jog operation			ON			OFF
command

1-15Auto-Acceleration / Deceleration

		Factory Setting: d0
Settings	d0	Linear Accel/Decel
	d1	Auto Accel, Linear Decel
	d2	Linear Accel, Auto Decel
	d3	Auto Accel/Decel (Set by load)
	d4	Linear Accel; Auto Decel, Stall Prevention during Decel
	d5	Auto Accel/Decel, Stall Prevention during Decel

If the auto acceleration/deceleration is selected, the AC drive will acceleration/deceleration in

the fastest and smoothest means possible by automatically adjusting the time of

acceleration/deceleration.

Revision August 2006, SE08, SW V2.61 5-25