Delta Electronics 115V Series manual Max Output Pr.1-00 Freq 60Hz, Parameters & Functions table

Chapter 5 ParametersVFD-S Series

Max.

Output Pr.1-00

Freq.

60Hz

anti-slope

Factory Settings

Pr.1-00=60Hz--Max. output Freq.

Pr.4-00=60Hz--Potentiometer bias freq. Pr.4-01=1 -- bias polarity

Pr.4-02=100% -- pot. freq. gain Pr.4-03=1 -- pot. REV. motion enable

	30
60	0
0V	Hz 10V
4mA	20mA

0Hz
0V	10V
4mA	20mA

Potentiometer Scale

4-04			Multi-function Input Terminal (M0, M1)
			Settings	d0 to d29		Factory Setting: d1
4-05			Multi-function Input Terminal (M2)
						Factory Setting: d6
4-06			Multi-function Input Terminal (M3)
						Factory Setting: d7
4-07			Multi-function Input Terminal (M4)
						Factory Setting: d8
4-08			Multi-function Input Terminal (M5)
						Factory Setting: d9
Parameters & Functions table:
	Value			Function	Value	Function
	d0	No Function			d15	Up: Increment master frequency
	d1	M0: FWD / STOP, M1: REV / STOP			d16	Down: Decrement master frequency
	d2	M0: RUN / STOP, M1: FWD / REV			d17	Run PLC Program
	d3	3-Wire Operation Control mode (M0,			d18	Pause PLC Program
		M1, M2)
	d4	External Fault (Normally Open)			d19	Counter Trigger Signal
	d5	External Fault (Normally Closed)			d20	Counter Reset
	d6	External Reset			d21	Select ACI / Deselect AVI (the priority is
						higher than Pr. 2-00 and d26)
	d7	Multi-Step Speed Command1			d22	PID function disable
	d8	Multi-Step Speed Command2			d23	JOG FWD
	d9	Multi-Step Speed Command3			d24	JOG REV
	d10	Jog operation			d25	The source of master frequency is AVI. (The
						priority is higher than Pr. 2-00 and d26)
	d11	Acceleration/Deceleration Speed			d26	The source of master frequency is ACI. (The
		Inhibit				priority is higher than Pr. 2-00)
	d12	First or Second Acceleration or			d27	Press UP/DOWN key to switch
		Deceleration Time Selection				forward/reverse (N.O.) motion
	d13	External Base Block (N.O.)			d28	Press UP/DOWN key to switch
		(Normally Open Contact Input)				forward/reverse (N.C.) motion
	d14	External Base Block (N.C.)			d29	M0: 0: RUN 1: STOP, M1: no function,
		(Normally Close Contact Input)				Direction is controlled by keypad

5-38 Revision August 2006, SE08, SW V2.61