Delta Electronics 230V Series, 460V Series, 115V Series manual Setting Function Description, Trg

Display (Pr.0-04=d1)

TRG

Counter Trigger Signal Multi-function Input Terminal

Preliminary Counter Value Attained Output (Pr. 3-04=d3)

(Pr. 3-05 to Pr. 3-06=d15)

Terminal Count Value Attained Output (Pr.3-03=d5)

(Pr.3-05 to Pr.3-06=d14)

Chapter 5 ParametersVFD-S Series

2ms

2ms

The width of trigger signal should not be less than 2ms(<250 Hz)

3-05Multi-function Output Terminal 1 (Photocoupler output)

Factory Setting: d1

3-06		Multi-function Output Terminal 2 (relay output)
						Factory Setting: d8
		Settings		d0 to d18
	Setting			Function	Description
	d0		No Function
	d1		AC Drive Operational		the output terminal will be activated when the drive is
					running.
	d2		Master Frequency Attained		the output will be activated when the AC drive attains
					Maximum Output Frequency.
	d3		Zero Speed		the output will be activated when Command Frequency
					is lower than the Minimum Output Frequency.
	d4		Over Torque Detection		the output will be activated as long as the over-torque is
					detected. Pr.6-04 determines the Over-Torque detection
					level.
	d5		Base-Block (B.B.) Indication		the output will be activated when the output of the AC
					drive is shut off by external Baseblock.
	d6		Low-Voltage Indication		the output will be activated when low voltage is detected.
	d7		Operation Mode Indication		the output will be activated when the operation of the AC
					drive is controlled by External Control Terminals.
	d8		Fault Indication		the output will be activated when faults occur (oc, ov,
					oH, oL, oL1, EF, cF3, HPF, ocA, ocd, ocn, GF).
	d9		Desired Frequency Attained		the output will be activated when the desired frequency
					(Pr.3-02)is attained.

Revision August 2006, SE08, SW V2.61 5-33