Delta Electronics 460V Series, 230V Series Group 6 Protection Parameters Explanation Settings

Chapter 5 ParametersVFD-S Series

Pr.	Explanation	Settings	Factory	NOTE
			Setting
5-02	3rd Step Speed Freq.	d0.0 to d400 Hz	d0.0
5-03	4th Step Speed Freq.	d0.0 to d400 Hz	d0.0
5-04	5th Step Speed Freq.	d0.0 to d400 Hz	d0.0
5-05	6th Step Speed Freq.	d0.0 to d400 Hz	d0.0
5-06	7th Step Speed Freq.	d0.0 to d400 Hz	d0.0
		d0: Disable PLC Operation
		d1: Execute one program cycle
		d2: Continuously execute program
		cycles
		d3: Execute one program cycle step
5-07	PLC Mode	by step	d0
		d4: Continuously execute one
		program cycle step by step
		d5: Disable PLC operation, but can
		set direction of 1st speed to 7th
		speed
5-08	PLC Forward/ Reverse Motion	d0 to d255 (0: FWD 1: REV)	d0
5-09	Time Duration of Zero Step Speed	d0 to d65500 Sec	d0
5-10	Time Duration of 1st Step Speed	d0 to d65500 Sec	d0
5-11	Time Duration of 2nd Step Speed	d0 to d65500 Sec	d0
5-12	Time Duration of 3rd Step Speed	d0 to d65500 Sec	d0
5-13	Time Duration of 4th Step Speed	d0 to d65500 Sec	d0
5-14	Time Duration of 5th Step Speed	d0 to d65500 Sec	d0
5-15	Time Duration of 6th Step Speed	d0 to d65500 Sec	d0
5-16	Time Duration of 7th Step Speed	d0 to d65500 Sec	d0
Group 6 Protection Parameters
Pr.	Explanation	Settings	Factory	NOTE
			Setting
6-00	Over-Voltage Stall Prevention	d0: Disable	d1
		d1: Enable
6-01	Over-Voltage Stall Prevention Level	115V/230V series: d350 to d410V	d390
		460V series: d700 to d820V	d780
6-02	Over-Current Stall Prevention Level	d20 to d150%	d130
		d0: Disabled
		d1: Enabled during constant speed
		operation. After the over-torque
		is detected, keep running until
		OL1 or OL occurs.
		d2: Enabled during constant speed
6-03	Over-Torque Detection Mode	operation. After the over-torque	d0
		is detected, stop running.
		d3: Enabled during running and
		continues before Continuous
		Output Time Limit (Pr.6-05) is
		reached
		d4: Enabled during running. After
		the over-torque is detected, stop
		running.
6-04	Over-Torque Detection Level	d30 to d200%	d150

Revision August 2006, SE08, SW V2.61 5-7