Delta Electronics 460V Series, 230V Series, 115V Series manual For Vfdxxxsxxe NPN sink mode

							Chapter 2 Installation and WiringVFD-S Series
For VFDXXXSXXE
NPN (sink mode)
						Braking resistor (optional)
				Jumper				select 80Ω 120W, 200Ω 120W
									400Ω 120W
Main Circuit Power				E	+1	+2/B1		B2	AC Motor
NFB							U/T1		IM
				R/L1
R/L1							V/T2
S/L2				S/L2		+17V			3~
							W/T3
T/L3				T/L3		CPU				Grounding resistance
								E
Recommended Circuit		SA	MC	RB						less than 100Ω
when power supply						2.4Ω			Potentiometer(1KΩ )
				RC			47Ω	AFM
is turned OFF by a	OFF	ON	MC
fault output									+
Factory default							47KΩ			Analog output
Forward/Stop				17V		11V			-	DC 0～10V
				M0
Reverse/Stop								GND	Factory default: indicate
				M1
Reset									output frequency
				M2		NPN		RA	Multi-function indication
Multi-step 1
				M3		PNP			output contacts below
								RB
Multi-step 2				M4	J2				120VAC/24VDC 5A
Multi-step 3								RC	Factory default:
				M5
Comm. signal (sink)									indicates malfunction
				GND
								Mo1
									Multi-function Photocoupler
				E
Analog voltage	3			+10V 10mA					output below 48VDC 50mA
									Factory default: Indicates
0～10VDC				(MAX)
Potentiometer Pot. 2				2	1		MCM		during operation
3K～5KΩ				AVI	3	47KΩ	RJ-11		RJ-11 communication port with
Analog current	1
				250Ω					RS-485 serial interface
				GND				6← 1	1:17V
Factory default: output freq. (Pot.)									2:GND
									3:SG-
determined by the Potentiometer
									4:SG+
on the control panel.
Main circuit (power) terminals				Control circuit terminals					Shielded leads

NOTE: Do not plug in a Modem or telephone line to the RS-485 communication port, permanent damage may result. Terminal 1 & 2 are the power sources for the optional copy keypad and should not be used while using RS-485 communication.

*If it is single phase model, please select any of the two input power terminals in main circuit power.

Revision August 2006, SE08, SW V2.61 2-19