Delta Electronics 230V Series, 460V Series, 115V Series manual Would be displayed as

Chapter 5 ParametersVFD-S Series

d4 Display forward/reverse command (Frd/rEv)

0-04	Content of Multi-function Display
		Factory Setting: d0
	Settings d0	Display the user-defined unit (u)
	d1	Display the counter value (C)
	d2	Display the content of PLC time (1.tt)
	d3	Display the DC BUS voltage (U)
	d4	Display the output voltage (E)
	d5	Display frequency commands of PID (P)
	d6	Display analog feedback signal value (b) (%)

		Display the user-defined unit, where unit = H X Pr.0-5-
0-05				User Defined Coefficient K		Unit: 0. 1
			Settings		d0.1 to d160	Factory Setting: d1.0
		The coefficient K determines the multiplying factor for the user-defined unit.
		The display value is calculated as follows:
		Display value = (output frequency x K)
		The display window is only capable of showing three digits, yet you could use Pr.0-05 to
		create larger numbers. The display windows uses decimal points to signify numbers up to five
		digits as illustrated in the following:
	Display					Number Represented
		999 The absence of a decimal point indicates a three–digit integer.
		99.9		A signal decimal point between the middle and the right-most numbers is a true
				decimal point; it separates ones and tenths as in “30.5” (thirty and one-half).
				A single decimal point after the right-most numbers is not a true decimal point,

999.instead it indicates that a zero follows the right-most number. For example, the number 1230 would be displayed as “123.”

Two decimal points (one between the middle and the right-most numbers, and

99.9.	one after the right-most number) are not true decimal points; instead they indicate
	that two zeros follow the right-most number. For example, the number 34500
	would be displayed as “34.5.”.

0-06	Software Version
	Settings	Read Only
	Display	d #.#

5-18 Revision August 2006, SE08, SW V2.61