Delta Electronics 115V Series, 230V Series, 460V Series manual D10 Jog Operation Control

Chapter 5 ParametersVFD-S Series

D7 Multi-step 1

Mx "Close": Operation available

Mx "Close": Operation available

D8 Multi-step 2

Mx "Close": Operation available

D9 Multi-step 3

GND

These three inputs select the multi-step speeds defined by Pr.5-00 to Pr.5-06 as shown in the following diagram. Pr.5-07 to Pr.5-16 can also control output speed by programming the AC drive’s

internal PLC function.

Freq. Pr.5-00				Pr.5-04
	Step 1				Step 5 Pr.5-05
		Pr.5-01
				Pr.5-03		Step 6
		Step 2
				Step 4
			Pr.5-02				Pr.5-06
			Step 3				Step 7
Master Freq.								Time
Mx1-GND	ON		ON		ON		ON
Mx2-GND		ON	ON			ON	ON
				ON
Mx3-GND					ON ON		ON
Operation				ON				OFF
Command

d10 Jog Operation Control:

Parameter value d10 programs Multi-Function Input Terminal: M1 (Pr.4-04), M2 (Pr.4-05), M3 (Pr.4- 06), M4 (Pr.4-07) or M5 (Pr.4-08) for Jog control.

Mx "Close": Operation available

d10 jog operation command

GND

NOTE

Jog operation programmed by d10 can only be initiated while the motor is stopped. (Refer to Pr.1-13, Pr.1-14.)

d11 Acceleration/Deceleration Speed Inhibit:

Parameter value d11 programs Multi-Function Input Terminal: M1 (Pr.4-04), M2 (Pr.4-05), M3 (Pr.4- 06), M4 (Pr.4-07) or M5 (Pr.4-08) for Acceleration/deceleration Inhibit. When the command is received, acceleration and deceleration is stopped and the AC drive maintains a constant speed.

Revision August 2006, SE08, SW V2.61 5-41