Chapter 1 IntroductionVFD-S Series

1.3 Installation Steps

KNOB

COVER

CASE

HEAT SINK

DIVISION

PLATE

SCREW

Installation Steps

1. Remove front cover screw and open.

2. Remove Division Plate. If using optional conduit bracket, please refer to next page.

3. Connect AC Input Power and motor leads.

Never connect the AC drive output terminals U/T1, V/T2, W/T3 to main AC Input power.

4. Reinstall Division Plate.

SCREW

SCREW

For Optional Conduit Bracket:

Make sure to fasten both screws on conduit bracket as shown in the drawing for safety grounding purpose. Bring all the wires out through the conduit bracket.

Screw Torque: 5 to 6 kgf-cm (4.3 to 5.2 in-lbf)

CONDUIT

BRACKET

Revision August 2006, SE08, SW V2.61

1-3

Page 12
Image 12
Delta Electronics 230V Series, 460V Series, 115V Series manual Installation Steps