Delta Electronics 115V Series manual Example 5 Pr -07 = d1 Execute one cycle of the PLC program

Chapter 5 ParametersVFD-S Series

Example 5 (Pr. 5-07 = d1 Execute one cycle of the PLC program):

In this example, the PLC program runs continuously. It should be noted that the times of reserve

motion may be shorter than expected, due to the acceleration/deceleration times.

Frequency

	Master freq.=5Hz
60Hz	5-00=10 Hz	4-07=d17	5-09=10 Sec
	5-01=20 Hz	3-05=d10	5-10=10 Sec
50Hz	5-02=40 Hz	3-06=d11	5-11=12 Sec
	5-03=60 Hz	5-07=d1	5-12=15 Sec
	5-04=50 Hz	5-08=d68	5-13=15 Sec
40Hz	5-05=30 Hz		5-14=8 Sec
	5-06=15 Hz		5-15=17 Sec
			5-16=17 Sec
FWD
15Hz
10Hz
0Hz			Time
			(Sec)
REV	5-09
20Hz
30Hz
	* The calculation of time for Pr.5-11, Pr.5-12, Pr.5-15 and Pr.5-16 should be carefully planned.

5-08	PLC Forward/Reverse Motion		Unit: 1
	Settings	d0 to d255	Factory Setting: d0

This parameter controls the direction of motion for the Multi-Step Speed Pr.5-00 to Pr.5-06 and the Master Frequency. The original direction of Master Frequency will become invalid.

NOTE

The equivalent 8-bit number is used to program the forward/reverse motion for each of the 8 speed steps (including Master Frequency). The binary notation for the 8-bit number must be translated into decimal notation and then be entered.

Weights								0=Forward
Bit	7	6	5	4	3	2	1	1=Reverse
								0

Director of Master Frequency during PLC

Direction of 1st speed for Pr.5-00

Direction of 2nd speed for Pr.5-01

Direction of 3rd speed for Pr.5-02

Direction of 4th speed for Pr.5-03

Direction of 5th speed for Pr.5-04

Direction of 6th speed for Pr.5-05

Direction of 7th speed for Pr.5-06

5-50 Revision August 2006, SE08, SW V2.61