Delta Electronics 230V Series, 460V Series, 115V Series manual Forward/reverse N.O. motion

Chapter 5 ParametersVFD-S Series

Pr.	Explanation	Settings	Factory	NOTE
			Setting
4-05	Multi-Function Input Terminal 2 (M2)	d10: Jog Operation	d6
		d11: Accel/decel Inhibit
	Multi-Function Input Terminal 3 (M3)	d12: First or Second
		Acceleration/deceleration Time	d7
4-06		Selection
		d13: External base block (N.O.)
		d14: External base block (N.C.)
	Multi-Function Input Terminal 4 (M4)	d15: Up: Increment master
		frequency
4-07		d16: Down: Decrement master	d8
		frequency
		d17: Run PLC Program
		d18: Pause PLC Program
		d19: Counter Trigger Signal
		d20: Counter Reset
		d21: Select ACI / Deselect AVI
		d22: PID Function Disabled
		d23: JOG FWD
		d24: JOG REV
		d25: The source of master
4-08	Multi-Function Input Terminal 5(M5)	frequency is AVI.	d9
		d26: The source of master
		frequency is ACI.
		d27: Press UP/DOWN key to switch
		forward/reverse (N.O.) motion
		d28: Press UP/DOWN key to switch
		forward/reverse (N.C.) motion
		d29: M0: 0: RUN 1: STOP, M1: no
		function, Direction is controlled
		by keypad
4-09	Line Start Lockout	d0: Disable	d0
		d1: Enable
		d0: Based on accel/decel time
		d1: Up frequency according to
		constant speed, down frequency
4-10	Up/Down Mode	according to deceleration time	d3
		d2: Up frequency according to
		acceleration time, down
		frequenc according to constant
		speed
		d3: Constant speed
	Accel/Decel Rate of Change of
4-11	UP/DOWN Operation with Constant	0~1000, unit: 5 Hz/sec	d1
	Speed
Group 5 Multi-Step Speed and PLC Parameters
Pr.	Explanation	Settings	Factory	NOTE
			Setting
5-00	1st Step Speed Freq.	d0.0 to d400 Hz	d0.0
5-01	2nd Step Speed Freq.	d0.0 to d400 Hz	d0.0

5-6 Revision August 2006, SE08, SW V2.61