Main
EXP1240 SIP DECT System: Installation Guide
Contents
Page
Table of Figures
List of Tables
Page
Introduction
Important Safety Instructions!
Check the Box Contents
About This Document
Purpose and Audience
Manual Conventions
Terms used in this manual
Table 1: Terms
Table 2: Abbreviations
Hardware Setup
Base Station
Figure 3 Connecting the base station
Table 3: Base station LEDs and their meanings
Wall mounting the base station Be sure the wall material can hold the weight of the base.
Figure 4: Base mounting dimensions
Page
Charging the battery
Figure 7: Installing the handset battery
Charge each battery completely (about 10 hours) before using it.
Figure 8: Inserting the handset into the charger
Powering on the Handset
Initial System Configuration
Table 4: Summary: Basic system configuration
Using the Base Station Interface
Figure 9:
screen
Configuring General System Settings
Change Configuration and Management Settings
Figure 10:
screen
Change the Default Password
Figure 11:
screen
Change the PSTN Tones and Emergency Dialing
If the system connects to the PSTN in the US or Canada, skip this section.
Configure the Network Settings Screen
Configure Time Settings
Figure 14:
screen
Figure 15: Checking time settings updates
Configuring the SIP Server Settings
Figure 16:
screen
Page
To edit an existing server
To delete a server
Program the SIP Extensions
Figure 17:
screen
Register Handsets to Extensions
Figure 18:
screen, no handsets registered
Figure 19:
screen, one handset registered
To deregister a handset
Multiple Base (Multi-cell) Systems
Introduction
Timing Levels
System Chain ID and RPN
Page
Table 5: Sample multi-cell system information
Setting Up a Multi-cell System
Table 6: Summary: Multi-cell system configuration
Configuring the Primary Base Station
Figure 22:
screen (default values)
Figure 23:
screen (primary base enabled)
Configuring Level 1 Base Stations
Page
Figure 26:
table, synchronization complete (
screen)
Figure 27:
table, Level 1 complete (
Configuring Base Stations at Level 2 and Up
Removing Base Station(s) from a Multi-Cell System
Changing the Primary Base Station in a Chain
Only perform this procedure when the system is offline or in a maintenance period.
Page
System Maintenance
Backing Up Configuration Settings
Figure 29:
screen
Restoring a Configuration
Updating the Firmware
Setting Up Firmware Folders
Valid server, folder, and firmware file name examples (base stations)
Valid server, folder, and firmware file name examples (handsets)
Configuring the Firmware Update Settings
Figure 30:
server information
Table 7 Firmware path examples
Updating Base Station Firmware
Figure 31:
screen
Updating Handsets
Figure 32: Firmware update progress (
screen)
To verify the firmware update
Appendix A: Software Reference
Base Station Configuration Interface
Available Screens
Global Buttons and Options
Home/Status Screen (Read Only)
Extensions Screen
Table 10:
options
Table 11:
parameters (read only)
Add Extension and Edit Extension screens
Table 12:
and
parameters
Servers Screen
Page
Network Screen
Table 15:
parameters
Table 16:
parameters
Table 17:
parameters
Table 18:
parameters
Table 19:
parameters
Management Screen
Table 20:
parameters
Page
Firmware Update Screen
Table 21:
screen options
Table 22:
parameters
, clicking Save will start the firmware update process for that handset type.
parameters
Time Screen
Table 25:
parameters
Page
Page
Importing a new file will replace the existing contact list.
Multi Cell Screen
Table 26:
parameters
Table 27:
parameters
Table 28:
parameters
Table 29:
parameters
Configuration Screen (read only)
Page
Page
Appendix B: RFPI Numbers