Uniden EXP1240 manual Base Station Group parameters, RPN Dect

EXP1240 System Installation Guide Revision 06

Parameter

SIP support for multiple registrations per account

Description

Select Enabled to allow more than one handset to use the same extension or SIP account; if this feature is not supported by the SIP server, this field is disabled.

	Table 29: Base Station Group parameters
Parameters	Description
	Displays the ID number of the base stations in this chain, usually
ID (chain)	corresponding to the order the base stations were added to the chain.
	(The same ID number might be used in other chains.)
	Displays the Radio Part Number (DECT network ID) of the base stations
RPN (DECT	on this chain. The RPN is automatically assigned by the system, and it
network)	must be unique on the local DECT network. (The same RPN might be
	used at remote locations.)
MAC Address	Displays the MAC address of each base station.
Version	Displays the current firmware version on each base station.
	– Connected: The base station is connected and functioning properly.
Status	– Connection Loss: The base station is not connected to the network.
	– This Unit: The base station is the one you are currently logged into.
	– Select the synchronization source for each base station on this
DECT Sync	chain. The primary base station has its own RPN as the sync source.
source	– The value in parentheses after the RPN shows the relative signal
	strength of the other base stations in this chain.
	– Primary: The designated base station serves as the primary
	synchronization source for this chain.
	– Locked: The base station is synchronized to its sync source.
DECT Property	– Searching: The base station is locating its sync source.
	– Free Running: The base station was locked, but it has since lost its
	synchronization source.
	– Unknown: There is no current connection to the base station.

© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 67 of 71