EXP1240 System Installation Guide | Revision 06 |
Charging the battery
1)Install the handset battery as shown below. (For more detailed instructions, see the End User’s Guide.)
Remove the battery cover from the back of the handset.
Figure 7: Installing the handset battery
Insert the bottom of the battery into the | Replace the battery |
compartment. Lay the battery down and | cover and slide it up |
push it gently until it snaps into place. | into place. |
|
|
2)Use the charger AC adapter to connect the charger's AC jack to a standard 120V AC power outlet.
3)Place the handset in the charger with the display facing forward. The HANDSET STATUS LED should turn on; if it doesn’t, reseat the handset or try plugging the AC adapter into a different outlet.
4)Place the spare battery (if available) in the back section of the charger; the BATTERY STATUS LED should turn on. (Pull the battery latch back slightly to fit the battery in the slot.)
Charge each battery completely (about 10 hours) before using it.
Figure 8: Inserting the handset
into the charger
Powering on the Handset
To power up the handset, press End. The handset searches for the base station or multi- cell chain it is registered to and connects to the unit with the strongest signal.
To power down the handset, press and hold End until the display turns off (about 4 seconds).
© 2013 Uniden America Corp. | PROPRIETARY AND CONFIDENTIAL | Page 14 of 71 |
