EXP1240 System Installation Guide | Revision 06 |
Color
Red
Red
State
Blinking
Blinking
Meaning
Factory reset warning. A factory reset has been initiated or is in progress.
No Ethernet connection available
OR
Handset registration failed.
Red
Briefly on
Reboot to start after firmware update.
Red
Flickering
Firmware update in progress.
Red
Steady on
Critical error. Contact technical support.
Wall mounting the base station
Figure 4: Base mounting dimensions
Be sure the wall material can hold the weight of the base.
1)Hold the base in its final location and mark the screw location based on the measurements shown.
2)Insert the appropriate anchors for the wall material.
3)Insert the mounting screws into the anchors, leaving about ¼ inch of space between the screw head and the wall.
4)Connect the Ethernet cable and route the cord as shown.
5)Place the base over the screw heads and slide it down into place.
© 2013 Uniden America Corp. | PROPRIETARY AND CONFIDENTIAL | Page 12 of 71 |
