Xerox 701P40211 manual User Account Management, Remote shell internet service

System Guide Security and Network Setup

Remote shell internet service

If you are using the legacy Xerox print command line client (the software is not distributed with this release), you will need to use the remote shell internet service to transfer files to the DocuSP controller. However, if you are not using the print command line client, it is strongly recommended that the remote shell internet service is disabled. When these three questions are answered, all remaining aspects of the "high" security setting are implemented.

disable-security and enable-security scripts

To disable security, run the disable-security script. It restores the system to the state it was before configure-xdss was run.

The enable-security script was designed as a companion to configure-xdss. It configures all of the changes in the “high” security setting, with the exception of the three questions asked by the configure-xdss script (anonymous LP, DigiPath, rsh).

enable-ftp and disable-ftp scripts

These scripts allow for enabling and disabling FTP alone. You must have FTP enabled when using a Continuous Feed system, or DigiPath Production Print and NetAgent.

FTP is also required for the iGen Call For Assistance (CFA) feature. This uses FTP to push IOT logs and a DocuSP outload back to the DocuSP controller.

enable-remote-diagnostics/disable-remote-diagnostics scripts

The enable-remote-diagnostics script re-enables the asppp daemon (asynchronous Point-to-Point Protocol), which is required for modem dial-in. The script also re-enables FTP and telnet because they are used in dialup sessions. All three of these services are disabled when the security setting is "High". The disable script disables them.

User Account Management

The following UNIX accounts are defined during the installation process:

Common Controller 4-11