
System Guide | Hints and Tips |
2.The user could pause the printer (the green button on the DocuSP GUI) until a large number of pages in the job have been RIPped. If the user then resumes the printer at the right time (some time before the whole job is RIPped), the print engine will print all of the queued pages and the controller will simultaneously finish ripping the remainder of the job. To do this successfully, the user will need to watch and compute the rate that DocuSP is ripping at. If you know how many pages are in the job, then knowing that the printer will generate paper at 60 ppm, you can compute how far from the end of the job to release the printer so that RIP and print finish at the same time.
PCI Channel Interface PWB Trace Capture Procedure
Load the PCI Channel Interface PWB Trace command when software is installed and the PCI Channel Interface PWB is detected. This procedure is usually performed at the request of Software Engineering or as part of a SPAR package.
Perform a Trace
To start the trace, perform the following:
1.Login as Administrator.
2.Select [System - Online Manager].
3.Select:
•Channel Gateway - Enable
•Input Device - Online
•Input Control - Start
4.Submit a job from the host.
5.After the job is completely received by the Controller, select Input Control - End.
6.Open a Terminal window.
7.Type cd /opt/XRXnps/XRXgrpset/bin and press <Enter>.
8.Type ./dspTrc > FileName.txt and press <Enter>.
9.Type ls
Common Controller |