Initial Setup

Manually Setting the Printer’s Ethernet Interface Speed

The printer’s Ethernet interface automatically detects the speed of your network. If your network is connected to another auto-sensing device, such as a hub, the hub may not detect the correct speed. Refer to the configuration page to make sure the printer has detected the correct speed of your network. To view the configuration page, see Accessing the Configuration Report on page 18.

To manually set the speed of the printer’s Ethernet interface:

Note: If your printer is locked, you must log in as a system administrator. For details, see Accessing CentreWare IS on page 17.

1.At the printer control panel, press the Machine Status button, then touch the Tools tab.

2.Touch Network Settings > Advanced. When the warning message displays, touch Continue.

3.Touch Ethernet Physical Media.

4.Select the Speed to match the speed set on your hub or switch.

5.Touch Save, then touch Close.

6.Press the Log In/Out button.

7.Touch Confirm to exit the Tools Pathway.

Assigning a Network Address

By default, the printer automatically acquires a network address from a DHCP server. To assign a static IP address, configure DNS server settings, or configure other TCP/IP settings, see TCP/IP on page 22.

16WorkCentre 7755/7765/7775 Multifunction Printer System Administrator Guide

Page 16
Image 16
Xerox 7755, 7765, 7775 manual Manually Setting the Printer’s Ethernet Interface Speed, Assigning a Network Address