Xerox 7775, 7765, 7755 manual Auto Upgrade

Models: 7755 7775 7765

1 185
Download 185 pages 13.21 Kb
Page 170
Image 170

Administrator Tools

Auto Upgrade

You can set the printer to automatically schedule printer software upgrades from a central FTP server at a specific time on a regular basis.

Caution:

This procedure deletes any current jobs in the printer print queue and prevents further jobs from printing until the upgrade has completed. If you wish to preserve these jobs, allow them to complete before upgrading your software.

All configured network settings and installed options will be retained by the printer after the Software Upgrade process.

Note: Upgrades must be enabled before you can configure Auto Upgrade.

1.Click Properties > General Setup > Machine Software > Auto Upgrade.

2.Under Auto Upgrade select Enabled for Schedule Upgrade. The Auto Upgrade page expands.

3.Under Refresh Start Time, select Hourly or Daily.

4.If you select Daily, type the Time in hours and minutes.

5.Under Protocol, select the address type. Options are IPv4 Address, IPv6 Address, or Host Name.

6.Type the appropriately formatted address and port number of the server where the upgrade software is located in the address field. The default port number is 21.

7.In the Directory Path field, type the full path to the software upgrade file in .dlm format located on the server.

8.Type the Login Name to access the server.

9.Type then retype the Password.

10.Click Apply.

Note: Software Installation begins several minutes after the software file has been submitted to the printer. Once installation begins, CentreWare IS is disabled. You can monitor the installation progress from the printer control panel.

170WorkCentre 7755/7765/7775 Multifunction Printer System Administrator Guide

Page 170
Image 170
Xerox 7775, 7765, 7755 manual Auto Upgrade