Yamaha III [F2] TYPE, [F3] SENS, B Gain, BPad Type, [F1] SELECT, Trigger Mode [TRIGGER], INPUT (Trigger Input jack), 1INPUT (Trigger Input jack)

	Reference
	Trigger Mode [TRIGGER]
Selecting the Trigger Setup	[F1] SELECT

Explanations about this display is described in the Quick Guide section on page 26.

NOTE

•Keep in mind that each number in the display corresponds to the number of the Trigger Input jack printed at the top of the front panel. Above each number, the status of the Trigger Signal received from the pad is shown in real time.

Selecting the Pad Type [F2] TYPE

From this display, you can set the type of pad or drum trigger connected to the Trigger Input jack. Make sure to select the appropriate type matching to the particular pad or drum trigger, in order to use it at its full potential.

mode Drum Kit mode Reference

2

1

BPad Type

Determines the pad type for the Trigger Input jack specified at 1. The list below shows the pad types that can be set for the connected pads or drum triggers.

Song

1INPUT (Trigger Input jack)

Determines a target Trigger Input jack. You can select the Trigger Input jack by hitting the desired pad when Input Lock (page 79) is turned off (when the L indicator is not shown at the right top of the LCD display).

Settings snare – pad15

Settings

KP125, KP65, TP120SD/100 (for snare), TP120SD/100 (for tom), TP65S (for snare), TP65S (for tom), TP65, PCY155, PCY135, PCY150S, PCY130SC, PCY130S/130, PCY65S/65, RHH135, RHH130, DT10/20 (for snare), DT10/20 (for HiTom), DT10/20 (for LoTom), DT10/20 (for Kick), TRG Snare, TRG HiTom, TRG LoTom, TRG Kick

mode Trigger mode Click mode

Trigger Sensitivity Settings [F3] SENS

From this display, you can set the sensitivity-related parameters, which determine how the DTXTREME III responds to the Trigger Signals received via the Trigger Input jacks. In other words, the parameters here determine how the level of the Trigger Signal (strength of your hits) is converted to the velocity recognized by the tone generator block. Keep in mind that the level and velocity generated by hitting a pad are shown at the top of the LCD display in real time.

1 3 2	5	4	1 INPUT (Trigger Input jack)
			Determines a target Trigger Input jack. You can select the
			Trigger Input jack by hitting the desired pad when Input Lock
			(page 79) is turned off (when the L indicator is not shown at
			the right top of the LCD display).
			Settings	snare – pad15

B Gain

Determines the gain with which the DTXTREME III receives the Trigger Signal from the pad. The higher the value, the more easily you can get sound even when hitting the pad softly.

Range 0 – 63

Sampling mode Chain mode Utility mode File

DTXTREME III Owner’s Manual 109