Yamaha III Resetting the User Memory to the Initial Factory Settings, ■Trigger Setup List, 1Checkbox, 4 Press the [ENTER/STORE] button

Setting Up

■Trigger Setup List

No.	Name		Description
PRE: 01	SP Wide		Wide dynamic range. This setting is designed for maximum expressive control, allowing
			performance subtleties over a wide dynamic range.
		For Special
PRE: 02	SP Normal		Normal setting
		Drum Set
PRE: 03	SP Narrow		Controlled dynamic range delivers stable trigger detection. This setting is designed for
			producing a smoother, more uniform sound with reduced volume fluctuations.
PRE: 04	STD Wide		Wide dynamic range. This setting is designed for maximum expressive control, allowing
			performance subtleties over a wide dynamic range.
		For Standard
PRE: 05	STD Normal		Normal setting
		Drum Set
PRE: 06	STD Narrow		Controlled dynamic range delivers stable trigger detection. This setting is designed for
			producing a smoother, more uniform sound with reduced volume fluctuations.
PRE: 07	DT10/20	—	Use for DT10/20 drum trigger systems applied to acoustic drums.
USR: 01 – 05	User Trigger	—	Allows creation of custom trigger setups.

* In the default setting, “PRE: 01 SP Wide” for Special Drum Set is selected.

Resetting the User Memory to the Initial Factory Settings

The original factory settings of this instrument’s User Memory (page 76) can be restored as follows. For each of all modes, you can set whether or not User Memory data is initialized.

CAUTION

•When the factory settings are restored, all the data you created in each mode will be erased. Make sure you are not overwriting any important data. Be sure to save all important data to a USB storage device before executing this procedure (page 114).

1 Press the [UTILITY] button to enter the Utility mode.

2 Press the [F6] FACTSET button to call up the Factory Set display.

1

1Checkbox

If you enter a checkmark for a mode name in the display (in step 3 below), executing the Factory Set will reset the User Memory data or settings of the corresponding mode to the initial factory settings. For those modes without checkmarks, the User Memory data or settings will be maintained even if Factory Set is executed.

3 Move the cursor to the checkbox of the desired mode then enter or remove the checkmark by using the data dial, [INC/ YES] button or [DEC/NO] button.

4 Press the [ENTER/STORE] button.The display prompts you for confirmation.Press the [DEC/NO] button or [EXIT] button to cancel the operation.5 Press the [INC/YES] button to execute the Factory Set operation.

After the Factory Set has been completed, a “Com- pleted” message appears and operation returns to the original display.

CAUTION

•For Factory Set operations that take longer to process, a message “Executing...” or “Please keep power on.” appears during process- ing. While such a message is shown (while data is being written to Flash ROM), never attempt to turn off the power. Turning the power off in this state results in loss of all user data and may cause the system to freeze (due to corruption of data in the Flash ROM). This means that this instrument may not be able to start up properly, even when turning the power on next time.

DTXTREME III Owner’s Manual 27