Prestige 642R Series ADSL Router
| Options. |
|
Rem IP Addr | Enter the IP address of the remote gateway. |
|
|
|
|
Edit IP/IPX/Bridge | Press [space bar] to select Yes and press [Enter] to go | Yes or No |
| to Menu 11.3 – Remote Node Network Layer |
|
| Options. |
|
Session Options: |
| Yes or No |
Edit Filter Sets | Press [space bar] to select Yes and press [Enter] to |
|
| open Menu 11.5 to edit the filter sets. See the Remote |
|
| Node Filter section for more details. |
|
PPPoE Idle Timeout (sec) | This value specifies the number of idle seconds that | 100 |
| elapse before the Prestige automatically disconnects | (default) |
| the PPPoE session. | |
|
| |
PPPoE Service Name | This is valid only when you have chosen PPPoE |
|
| encapsulation. If you are using PPPoE encapsulation, |
|
| then type the name of your PPPoE service here. |
|
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [Enter] at the message [Press ENTER to Confirm … ] to save your configuration, or press [Esc] at any time to cancel.
4.1.3 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons. However, some vendor’s implementation includes specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated protocol is stronger than specified. If you encounter the case where the peer disconnects right after a successful authentication, please make sure that you specify the correct authentication protocol when connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 – Remote Node Profile, and use [space bar] to select Yes. Press [Enter] to open Menu 11.2, as shown next.
Remote Node Configuration |
