ZyXEL Communications 642R Series manual Hardware Installation & Initial Setup

Prestige 642R Series ADSL Router

Chapter 2

Hardware Installation & Initial Setup

This chapter describes the physical features of the Prestige and how to make the cable connections.

2.1Front Panel LEDs of the P642R

The LED indicators on the front panel indicate the operational status of the Prestige 642. The table below the diagram describes the LED functions:

	Figure 2-1	Prestige 642R Series Front Panel.
	Table 2-1	Front Panel LED Description
PWR	The PWR (power) LED is on when power is applied to the Prestige.
SYS	A steady ‘on’ SYS (system) LED indicates the Prestige is on and functioning
	properly while an ‘off’ SYS LED indicates the system is not ready or has a
	malfunction. The system is rebooting when the SYS LED is blinking.
LAN 10M	A steady light indicates a 10Mb Ethernet connection. The LED will blink when data
	is being sent/received.
LAN 100M	A steady light indicates a 100Mb Ethernet connection. The LED will blink when data
	is being sent/received.
ADSL	The ADSL LED is on when the Prestige is connected successfully to a DSLAM. The
	LED blinks when data is being sent/received. The LED is off when the link is down.

2.2Rear Panel and Connections of the Prestige 642R

The following figure shows the rear panel connectors of your Prestige:

Hardware Installation & Setup 2-1