Prestige 642R Series ADSL Router

6.4.1 IPX Remote Node Setup

Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 – Remote Node Profile. For the IPX-related parameters in Menu 11.3 – Remote Node Network Layer Options, follow the instructions below.

To edit Menu 11.3 – Remote Node Network Layer Options shown in Figure 6-5,follow these steps:

Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should display Route= IPX, or IP + IPX.)

Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the [space bar] to set the value to

Yes, and press [Enter] to open Menu 11.3 Remote Node Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

VPI/VCI (LLC-mux or PPP/PPPoE) Encap: IPX Options:

VPI #= 0

Rem LAN Net #= 00000000

VCI #= 35

My WAN Net #= 00000000

IP Options:

Hop Count= 1

Rem IP Addr: N/A

Tick Count= 2

Rem Subnet Mask= N/A

W/D Spoofing(min)= N/A

My WAN Addr= N/A

SAP/RIP Timeout(min)= N/A

Single User Account= N/A

Dial-On-Query= N/A

Metric= N/A

 

Private= N/A

Bridge Options:

RIP Direction= N/A

Dial-On-Broadcast= N/A

Version= N/A

Ethernet Addr Timeout(min)= N/A

Multicast= N/A

 

IP Policies= N/A

 

Enter here to CONFIRM or ESC to CANCEL:

Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options

6-6

IPX Configuration

Page 85
Image 85
ZyXEL Communications 642R Series manual IPX Remote Node Setup, Menu 11.3 Remote Node Novell IPX Options