
Prestige 642R Series ADSL Router
.
Figure 5-4 Sample IP Addresses for a TCPI/IP LAN-to-LAN Connection
To configure the TCP/IP parameters of a remote node, first configure the three fields in Menu 11.1 – Remote Node Profile, as shown in the table below.
| Table |
|
|
FIELD |
| DESCRIPTION | OPTION |
|
|
| S |
Route | Make sure IP is among the protocols in the Route field in Menu 11.1 – | IP | |
| Remote Node Profile. |
| |
Rem IP | Enter the IP address of the remote gateway in Menu 11.1 – Remote Node |
| |
Address | Profile. You must fill in either the remote Prestige WAN IP address or the |
| |
| remote Prestige LAN IP address. This depends on the remote router’s WAN |
| |
| IP i.e., for the (remote) Prestige, the My WAN Addr settings in Menu 11.3. |
| |
| For example (see previous Figure), if the remote WAN IP is set to |
| |
| 172.16.0.2 (the remote router’s WAN IP), then you should enter 172.16.0.2 |
| |
| in the Rem IP Addr field. If the remote WAN IP is 0.0.0.0, then enter |
| |
| 192.168.1.1(the remote router’s LAN IP) in the Rem IP Addr field. |
| |
Edit IP | Press [space bar] to toggle this field to Yes and then press [Enter] to go to | Yes or | |
| Menu 11.3 – Remote Node Network Layer Options menu. | No | |
|
|
|
|
The following table shows the
Remote Node TCP/IP Configuration |