ZyXEL Communications 642R Series manual Ethernet IP Policies, 11-5

	Prestige 642R Series ADSL Router
Precedence	Precedence value of the incoming packet. Values range from [0] to [7] or [Don’t
	Care].
Source:
addr start= /	Source IP address range from start to end.
end=
port start= /	Source port number range from start to end; applicable only for TCP/UDP.
end=
Destination:
addr start= /	Destination IP address range from start to end.
end=
port start= /	Destination port number range from start to end; applicable only for TCP/UDP.
end=
Action=	Specifies whether action should be taken on criteria [Matched] or [Not
	Matched].
Gateway addr	Defines the outgoing gateway address. The gateway must be on the same
	subnet as the Prestige if it’s on the LAN, otherwise, the gateway must be the IP
	address of a remote node. The default gateway is specified as 0.0.0.0.
Log	Press [SPACE BAR] to select Yes to make an entry in the system log when a
	policy is executed.
Type of Service	Set the new TOS value of the outgoing packet. Choose from Prioritize incoming
	network traffic by choosing from [No Change] / [Normal] / [Min Delay] / [Max
	Thruput] / [Max Reliability].
Precedence	Set the new precedence value of the outgoing packet. Values range from [0] to
	[7] or [No Change].

11.2 Applying an IP Policy

This section shows you where to apply the IP Policies after you design them.

11.2.1 Ethernet IP Policies

From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -General Ethernet Setup.

You can choose up to four IP Policy sets (from twelve) by entering their numbers separated by commas, e.g., 2, 4, 7, 9.

IP Policy Routing 11-5