ZyXEL Communications 642R Series manual Menu 11.3 Remote Node Network Layer Options

Prestige 642R Series ADSL Router

Menu 11.3 - Remote Node Network Layer Options

VPI/VCI (LLC-mux or PPP/PPPoE Encap): IPX Options:

VPI #= 0	Rem LAN Net #= N/AS
VCI #= 35	My WAN Net #= N/A
IP Options:	Hop Count= N/A
Rem IP Addr: 0.0.0.0	Tick Count= N/A
Rem Subnet Mask= 0.0.0.0	W/D Spoofing(min)= N/A
My WAN Addr= 0.0.0.0	SAP/RIP Timeout(min)= N/A
Single User Account= Yes	Dial-On-Query= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1	Bridge Options:
Multicast= None	Dial-On-Broadcast= No
IP Policies=	Ethernet Addr Timeout(min)= 0

Enter here to CONFIRM or ESC to CANCEL:

Figure 7-2 Menu 11.3 - Remote Node Network Layer Options

The following table describes the bridging-dependent parameters in the Remote Node Profile and Network Layers menus.

Table 7-2		Remote Node Network Layer Options
FIELD		DESCRIPTION
Bridge (Menu 11.1)	Make sure this field is set to Yes.
Edit IP/IPX/Bridge	Press [space bar] to change it to Yes and press [Enter] to go to the Remote
(Menu 11.1)	Node Network Layer Options menu.
Dial-On-Broadcast	This field is necessary for your Prestige on the caller side LAN. When set to
(Menu 11.3)	Yes, any broadcasts coming from the LAN will trigger your Prestige to make
	a call to this remote node. If it is set to No, your Prestige will not make the
	outgoing call.
Ethernet Addr Timeout	In this field, enter the time (number of minutes) that you wish your Prestige to
(min) (Menu 11.3)	retain the Ethernet Address information in its internal tables while the line is
	down. If this information is retained, your Prestige will not have to recompile
	the tables when the line is brought back up.

Once you have completed filling in the Remote Node Network Layer Options menu, press [Enter] to return to Menu 11.1. Then press [Enter] at the message [Press ENTER to Confirm…] to save your configuration, or press [Esc] to cancel.

Bridging Setup 7-3