Prestige 100L IDSL Router
Session Options: | In these fields, select which filter set(s) you would like to | No/Yes |
Edit Filter Sets | implement to filter the incoming and outgoing traffic between this |
|
| Remote Node and your Prestige. You can choose from 12 |
|
| different filter sets. In addition, you can link up to 4 filter sets |
|
| together for further customization (e.g., 1, 5, 9, 12). Note that |
|
| spaces and “,” are accepted in this field. |
|
| For more information on customizing your filter sets, see Chapter |
|
| 6. The default is blank, i.e., no filters defined. |
|
4.1.1 Editing PPP Options
Menu 11.2 - Remote Node PPP Options
Encapsulation = Standard PPP
Compression = No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
| Figure | Menu 11.2 Remote Node PPP Options |
| ||
| Table | Fields in Menu 11.2 (PPP Options ) |
| ||
|
|
|
|
|
|
FIELD |
|
| DESCRIPTION |
| EXAMPLES |
|
|
|
|
| |
|
|
|
|
| |
Encapsulation |
| Select CCP (Compression Control Protocol) for the PPP |
| Standard | |
|
| or MP link. There are two options in this field: |
| ||
|
|
| PPP / CISCO | ||
|
| ∙ Standard PPP – Standard PPP options is used. |
| ||
|
|
| PPP | ||
|
| ∙ CISCO PPP – CISCO PPP options is used. |
|
| |
Compression |
| Turns on Stac Compression. The default for this field is |
| No/Yes | |
|
| Off. |
|
|
|
Once you have completed Menu 11.2 – Remote Node PPP Options, press the [Enter] key at the message “Press ENTER to Confirm . . . to confirm your selections or press ESC to cancel your selections”.
4.2Editing TCP/IP Options
Move the cursor to the Edit IP field in Menu 11.1, then press the [space bar] to toggle and set the value to Yes. Press the [Enter] key to open Menu 11.3 – Remote Node Network Layer Options.
This section shows you how to configure your Prestige for TCP/IP. Depending on your particular applications, you need to configure different menus. For instance, Internet access is the most common application of TCP/IP. For this application, you should configure Menu 4. Configuration for other applications is shown in the following sections.
Remote Node Setup |
