ZyXEL Communications Prestige 100L manual Remote Node Network Layer Options

Prestige 100L IDSL Router

Menu 11.3 - Remote Node Network Layer Options

Rem IP Addr: 0.0.0.0

Rem Subnet Mask = 0.0.0.0

My WAN Addr = 0.0.0.0

Single User Account = Yes

Metric = 2

Private = No

RIP Direction = Both

Version = RIP-2B

Enter here to CONFIRM or ESC to CANCEL:

	Figure 4-4		Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 4-4		Remote Node Network Layer Options Menu Fields
FIELD			DESCRIPTION	EXAMPLE
Rem IP Addr	This shows the IP address you entered for this Remote Node in the
	previous menu.
Rem Subnet	Enter the subnet mask for the remote network.
Mask
My WAN Addr	Some implementations, especially the UNIX derivatives, require
	hosts on both ends of the ISDN link to have separate addresses
	from the LAN, and that the addresses must have the same network
	number. If this is the case, enter the IP address assigned to the
	WAN.
Single User	This field set to Yes to enable the Single User Account (Network			Yes/No
Account
	Address Translation) feature for this site. Use [space bar] to toggle
	between Yes and No.
Metric	Metric represents the “costs” of transmission for routing purposes. IP
	routing uses hop count as the measurement of cost, with a minimum
	of 1 for directly connected networks. Enter a number that
	approximates the cost for this link. The number need not be precise,
	but it must be between 1 and 16. In practice, 2 or 3 is usually a good
	number.
Private	This parameter determines if your Prestige includes the route			No/Yes
	to this Remote Node in its RIP broadcasts. If set to Yes, this
	route is kept private and not included in RIP broadcast. If No,
	the route to this Remote Node is propagated to other hosts
	through RIP broadcasts.
RIP Direction	This parameter determines how your Prestige handles RIP (Routing			Both/In

Remote Node Setup 4-5