Philips FR-986, FR-995 Power, Speaker connections, TV as the center speaker Antenna connections

CONNECTIONS

Power

The type plate is located on the rear of the receiver.

1Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organization.

2Connect the power cord to the power outlet.

To disconnect the unit from the power completely, remove the power plug from the power outlet.

Speaker connections

Some of the speaker connections on the receiver are screw connectors and some are click-fit connectors. Use them as shown below.

7 mm

123

8 mm 1 2 3

1Always connect the colored (or marked) wire to the colored terminal and the black (or unmarked) wire to the black terminal.

2Connect:

–Left front speaker to L (red and black)

–Right front speaker to R (red and black)

–Center speaker to CENTER (blue and black)

–Left surround speaker to SURROUND L (grey and black)

–Right surround speaker to SURROUND R (grey and black)

TV as the center speaker

You may use your Philips TV with CINEMA LINK as the center speaker. For TV’s with cinch connectors, additional cinch cables are needed. These cables must be connected to the blue CENTER PRE-OUT connector on the back. Look into the instruction manual of your TV on how to use it as the center speaker.

Antenna connections

AM (MW) antenna

The loop antenna supplied is for indoor use only. Position the antenna as far away as possible from the receiver, a TV, the cables, a DVD player, a VCR and other radiation sources.

1Fit the plug of the frame antenna to AM LOOP as shown below.

2Turn the antenna for optimum reception.

ANTENNA

AM LO OP

FM antenna

The wire antenna supplied can be used only to receive nearby stations. For better reception we recommend using a cable antenna system or an outdoor antenna.

1Open the FM 300 Ω click-fits by pushing the lever down as shown below.

2Insert each wire of the antenna into one hole.

3Close the click-fits using the lever.

4Move the antenna in different positions for optimum reception.

8 mm 1 2 3

The unit complies with the FCC-Rules, Part 15. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired

operation.

English

13