Philips FR-995, FR-985, FR-994 PLAYBACK, Recording, English Playing a source, Adjusting the sound

Page 20

PLAYBACK, RECORDING

English

Playing a source

1Press POWER / STANDBY to switch on the receiver.

2Turn SOURCE SELECT to select a source. yThe name of the source is displayed.

You can select the FRONT AV/GAME input by pressing FRONT AV (FR 995, FR 996 only).

3Start playback of the source as usual.

Adjusting the sound

Turn VOLUME to adjust the volume.

yVOLUME and the volume level between 0 and 50 is displayed.

1Press BASS or TREBLE.

yBASS or TREBLE and the actual value are displayed briefly. Then TURN VOLUME KNOB TO CHANGE is scrolled.

2Turn VOLUME to adjust the bass or treble.

yBASS or TREBLE and the actual value are displayed.

Note: If VOLUME is not turned within 5 seconds or if any other control is used, the bass or treble adjustment is switched off.

FR 963, FR 985, FR 986 only:

Press ±SOUND on the remote control to scroll through the built-in smart sounds: MOVIE, SPEECH, MUSIC, MULTIMEDIA and PERSONAL. (PERSONAL is the userdefined bass and treble setting.)

ySMART SOUND is displayed and the name of the chosen sound profile is scrolled once if smart sound is on.

FR 994, FR 995, FR 996 only:

If a subwoofer is connected, press SUBW. ON/OFF to increase the bass performance.

Note: In case of digital surround sound, a subwoofer signal will only be available when supported by the source material.

Press LOUDNESS to switch on or off loudness. yLOUDNESS is displayed if loudness is on.

Recording from a source

If you wish to record from a source you must select it with SOURCE SELECT. The incoming signal is reproduced by all audio and – if the source includes a video signal – video outputs of the receiver. The sound settings do not affect the recording.

1Turn SOURCE SELECT (or press FRONT AV – FR 995, FR 996 only) to select the source you want to record from. yThe name of the source is displayed.

2Prepare the desired recording appliance. It must be connected to one of the outputs of the receiver.

3Start recording on the recording appliance.

4Start the playback of the source as usual.

Notes: – The audio and video signal of VCR IN is not reproduced by VCR OUT. The same applies to the audio signal of CDR/TAPE IN to CDR/TAPE OUT.

We recommend not to use the digital output

COAX OUT of the receiver to record from an analog source. Use the analog output CDR/TAPE instead.

From a source which is connected to the

6 CHANNEL / DVD INPUT audio input cannot be recorded.

Recording from the digital output

It is possible to connect a digital recorder to the digital output of the receiver. In this way, all signals coming from the digital inputs can be recorded directly on the connected audio recorder. The receiver will also convert all signals coming from the analog inputs to the digital output.

The receiver can be used to record digitally a multichannel surround sound audio signal (Dolby Digital or DTS) from, for example, DVD to CD-R. The receiver will convert the digital multichannel signal into a stereo signal without loss of relevant sound information.

Notes: – Do not use the 3D SURROUND feature while making digital recordings as this will distort the digital audio signal (FR 963, FR 985, FR 986 only).

When recording a Dolby Digital or DTS signal, each track must be recorded individually.

Digital recording is not possible when the digital source material is copy-protected.

20

Image 20
Contents Audio For Customer Use Prevent operating and maintenance problemsDear Philips product owner Canada Español Français EnglishImportant Safety Instructions Class II equipment symbolEnglish EL 6475-E003 01/6Setup General InformationScope of supply Environmental informationEnglish PREV. / ExitRemote Control Remote control use EnglishRemote control and insert FR 994, FR 995, FREnglish Remote control buttons Scanning the codetable Resetting the remote controlProgramming with the 4-digit code Connectors Connectors name Connect to $ TVCoax 1 Coax 2Digital audio connections ConnectionsAnalog audio connections Video connections System control bus, Cinema LinkPower Speaker connectionsTV as the center speaker Antenna connections AM MW antennaSystem Setup Receiver adjustment Speaker diagram DisplayEnglish Display Status lightsMenus Receiver menuYou can exit the menu at any time by pressing Menu structureActivating Cinema Link Switching the connectionTV menu Source Selection Source SelectAdjusting the sound PLAYBACK, RecordingEnglish Playing a source Recording from a sourceAbout surround sound Switching surround sound Surround SoundVirtual Surround Surround sound settingsNight Mode only on the remote control Tuning to radio stations Switching FM sensitivityTuner Storing radio stationsEnglish Tuning to stored radio stations Resorting stored radio stationsNaming radio stations Clearing station namesTechnical Data ReceiverTroubleshooting Problem Possible Cause SolutionModel # Serial # Your warranty does not coverPlease contact Philips at French Speaking English Speaking Cher possesseur de produit Philips Cet espace vous est réservéEL 6475-F002 01/6 Français Symbole d’ un appareil de classeConsignes DE Sécurité Importantes Generalites Produits livrés avec l‘équipementMise en place Informations relatives à l‘environnementCommandes Telecommande Utilisation de la télécommandeBoutons de la télécommande Mettez en service l‘application à commander Réinitialisation de la télécommandeProgrammation avec le code à 4 chiffres Balayage de la table des codesConnecteurs Connexions audio numériques ConnexionsConnexions audio analogiques Français Bus de commande système, Cinema Link Connexions vidéoAu démarrage d‘une source, le système passe Automatiquement à l‘entrée concernéeFrançais Secteur Connexions des enceintesConnexions d‘antenne Antenne AM MWInstallation DU Systeme Français Réglage du récepteur Deux haut-parleurs arrière présents Subwoofer présentAffichage AffichageFrançais Menu récepteur Structure de menuRéalisation de la connexion Menu téléviseurPour activer Cinema Link Selection DE Source Sélection 6 CHANNEL-DVD/SACD InputRéattribution d‘une sélection de source Propos de 6 CHANNEL-DVD/SACD InputPropos DE LA LECTURE, Enregistrement Lecture d‘une sourceRéglage du son Enregistrement d‘une sourceFrançais Propos du son surround Mise en service du son surroundSON Surround Surround Virtuel Night Mode uniquement sur la télécommandeRéglages du son surround Syntoniseur Français Syntonisation des stations radioSélection de sensibilité FM Mémorisation des stations radioOu si vous changez d‘avis Dénomination des stations radioEffacement des noms de station Caracteristiques Techniques Français RécepteurProbleme Cause Possible Solution Depistage DES AnomaliesVeuillez contacter Philips á Francophone Anglophone Nº DE Modèle Nº DE SérieEstimado dueño del producto Philips Para uso del clienteInstrucciones Importantes DE Seguridad EspañolEL 6475-S002 01/6 Coloque el equipo exclusivamente sobreConfiguración Información GeneralLista de componentes Información medioambientalControles EspañolPeríodo, extráigalas del compartimento Mando a DistanciaUtilización del mando a distancia Español Botones del mando a distancia Programación con el código de 4-dígitos Búsqueda en la tabla de códigosEncienda el aparato que desea manejar Pulse y suelte de nuevoPara la toma de auriculares de 6,3 mm en la parte frontal Consolas de videojuegosPara los altavoces frontales izquierdo y derecho Para el altavoz centralConexiones de audio digitales ConexionesConexiones de audio analógicas Conexiones de vídeo Sistema de control en bus, Cinema LinkAlimentación Conexiones de las antenasEspañol Conexiones de los altavoces El TV como altavoz centralConfiguración DEL Sistema Ajuste del receptor Consulte las hojas de especificaciones de los altavocesPantalla Español PantallaEstructura del menú MenúsMenú del receptor Activación/desactivación de la conexión Menú del TVActivado de Cinema Link Selección DE Fuente Selección 6 CHANNEL-DVD/SACD InputPara reasignar una selección de fuente Acerca de 6 CHANNEL-DVD/SACD InputREPRODUCCIÓN, Grabación Español Reproducción de una fuenteAjuste del sonido Grabación de una fuenteSonido Envolvente Ambiente virtual Night Mode sólo en el mando a distanciaAjustes del sonido envolvente Sintonizador Para sintonizar las emisoras de radioActivación de la sensibilidad FM Almacenamiento de emisoras de radioPara asignar un nombre a una emisora Para borrar los nombres de las emisorasUtilice la opción del menú * TUNER, seleccione Si cambia de ideaDatos Técnicos ReceptorEntradas SalidasSolución DE Problemas Problema Causa Posible SoluciónDisponibles ¿QUE Excluye LA GARANTIA?Favor de comunicarse con Philips al Francófono Anglófono English Français Español Cable BOXTape DVD0119, 0030, 0207, 0478 00870043 0030, 0263VCR SAT Page Philips Consumer Electronics Company