ATS Component Details
ATS label kit
ATS Label—Place this label on the outside of the ATS enclosure to identify the ATS, and to associate it with the appropriate source: either Source 1 or Source 2.
Source Label—Use a Source 1 label at the primary utility breaker to identify which ATS it is feeding. Use a Source 2 label in instances where a secondary utility breaker is employed instead of a generator.
Generator Label—Use these labels (3 total) at the generator to identify which ATS it is feeding. Place one label on each long side of the generator near the brand name labels, and place one label on the door where the generator controller is located.
Single-PoleLabel—Use these labels with each single-pole breaker on the ATS distribution panel to identify which data center equipment it is feeding. Use the marker (supplied) to write on the label.
Three-Pole Breaker Label—Use these labels with each three-pole breaker on the ATS distribution panel to identify which data center equipment it is feeding. Use the marker (supplied) to write notes on the lower portion of the label. The labels are customized for typical components in an InfraStruXure system. Blank labels are also included for components that do not have pre-marked labels.
Front Bezel Label—If not employing a generator for Source 2, use one of these labels to replace the Generator Power System label on the left- hand side of the bezel. You can use either the Automatic Transfer Switch or the Standby Power System label to describe your system.
ATS Dead Front Source Label—Use these alternate labels for Source 1 and Source 2 if you do not want Utility and Generator to describe your sources. These labels allow you to use Primary and Secondary or Normal and Alternate to describe Source 1 and Source 2.
18 | InfraStruXure Power Generation System |