Agilent Technologies FS2331 user manual Filtering

Page 25

After clicking “next” you must browse for the fast binary data file you want to import. Once you have located the file and clicked start import, the data should appear in the listing.

After the data has been imported you must load the protocol decoder before you will see any decoding. To load the decoder select Tools from the menu bar, when the drop down menu appears select Inverse Assembler, then choose the name of the decoder for your particular product. The figure below is a general picture; please choose the appropriate decoder for the trace you are working with.

After the decoder has loaded, select Preferences from the overview screen and set the preferences to their correct value in order to decode the trace properly.

Filtering

The offline IA allows filtering just like the 16700/702 environments. You may filter on any label, when using the filter tags label you can select symbols to make choosing transactions easier. To create a filter, choose Tools, New, Filter/Colorize. Then fill in the information on the window that opens up. You must create a new filter for each item you want filtered. It is best to filter out transactions you don’t want on the 16700/702 rather than waiting and filtering on the captured data. To remove filters that you no longer want, go to Tools, Overview and then choose the filter you want removed and press Delete.

25

Image 25

Contents Revision DDR Sdram Analysis Probe FS2331How to reach us Product Warranty Signal Connections For Sales and Marketing Support For Technical SupportLimitation of warranty Product WarrantyExclusive Remedies Introduction Probe Cable, Connector NumberingDefinitions Logic Analyzer ModulesFS2331 100 pin Connector to Pod Diagram FS2331 Probe Description Probe Feature SummaryProbe Components Probe Design DDR CommandsState Clock Generation DDR DataPage Pod Clock Domain Clock Rate Probe Pod AssignmentProbe Switch Settings Switch # Default factory Function PositionOn closed Connecting the Probe to the Logic Analyzer Logic Analyzer Signal Threshold Voltage SettingsConnecting Power to the FS2331 Probe Card Requirements for PC2700 Systems 16753/4/5/6 Logic Analyzer Card RequirementsRecommended Setting up the 169xx Analyzer Setting up the 167xx AnalyzerSoftware Requirements System Software 169xx LicensingTiming Analysis All DDR speeds and supported analyzer cards Card Configurations for State Analysis Probing multiple DDR busses Interleaved memory If User is dedicating a Connecting to your Target System Chip Select§ Isolate the Dedicated DIMM’s pin Chip Select Jumper locations§ Sleeve the Pin Unused Pods § Wire from the adjacent Dimm slot to the isolated pinOffline Analysis Filtering Timing Analysis Operation Loading the Inverse Assembler and Decoding DDR CommandsState Analysis Operation Taking a Trace, Triggering, and Seeing Measurement ResultsInverse Assembler and Decoding DDR Commands Tracing the Serial Presence Detect Signals Using Eye Finder with the FS2331 DDR Probe Using EyeScan with the FS2331 Probe Dimm Signal Loading Option Using the FS2331 DDR Probe with an Interposer FS1024/25FS2331 Calibration Page Set Command sample position Page Page Write Burst Data Valid Position Page Page Page Read Burst Data Valid Position Page Page Page Set the final analyzer sample position Adjust the delay line value to maximize R/W overlapPage Standards supported General InformationSamtec Signal Connections J1 DataSA0 CB4 J2 Data and CommandSpare J3 Command and Data Buffcmdclk DM5DQS14 J4 DataDQS7