![](/images/new-backgrounds/1156698/15669837x1.webp)
2. Preparation
2.5Adjusting cordless handset volume
{^}{V}{<}{>}{ih}
Ringer volume
1."
2.Select Nby pressing {^}, {V}, {<}, or {>}. i #
3.Press {^} or {V} to select “Ringer Setup”. i
4.Press {^} or {V} to select “Ringer Volume”. i
5.Press {^} or {V} to select the desired volume. i
#i {ih}
Note:
LWhen the ringer volume is turned OFF, Uis displayed.
When the ringer is turned OFF, the cordless handset will ring:
–at the minimum level for alarm and intercom calls
–at the maximum level for paging
Ringtone
You can select the desired cordless handset ringtone for outside calls and intercom calls (page 56). Caller ID service users can also use a different ringer for each category (page 29).
Cordless handset receiver volume While using the receiver, press {V} or {^}.
Speaker volume
While using the speakerphone, press {V} or {^}.
2.6 Adjusting base unit volume
{SET}
{A}{B}
Ringer volume
While the unit is idle, press {A} or {B}.
LIf there are any documents in the document entrance, you cannot adjust the volume. Confirm that there are no documents in the entrance.
To turn the ringer OFF
Press {B} repeatedly to display “RINGER OFF= OK?”.
i{SET}
LThe base unit will not ring for outside calls.
The base unit will ring at the low level for intercom calls.
LTo turn the ringer back ON, press {A}.
Ringtone
LYou can select the desired base unit ringtone for outside calls (feature #17 on page 51).
Handset receiver volume
While using the receiver, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or {B}.
19