II
REGULAR CLEANING (cont.)
Storing the Washer
If the washer will not be used for an extended period of time and is in an area that could be exposed to freezing temperatures:
_1 Turn off water supply tap.
Disconnect hoses from water supply and drain water from hoses.
Plug the power cord into a properly grounded electrical outlet.
Add 1 gallon of nontoxic recreational vehicle (RV) antifreeze to the empty wash tub. Close the lid.
Select the spin cycle and let washer spin for 1 minute to drain out all the water.
NOTE: Not all of the RV antifreeze will be expelled.
0Unplug the power cord, dry the tub interior with a soft cloth, and close the lid.
_1 Remove the inserts from the dispenser. Drain any water in compartments and dry the compartments.
Store the washer in an upright position.
To remove the antifreeze from the washer after storage, run washer through a complete cycle using detergent. Do not add laundry!
MAINTENANCE
Cleaning the Water Inlet Filters
If the washer detects that water is not entering the washer, an error message will show on the display. If you live in an area with hard water, this may be caused by clogged inlet filters.
Turn off both water taps completely. Unscrew the hot and cold water lines from the back of the washer.
IMPORTANT: Use extreme care when removing and cleaning the filters. If the filters cannot be cleaned or are damaged, do NOT operate the washer, as foreign particles could cause the valves to stick open, flooding the laundry room. Contact KENMORE customer service to have the fill valve replaced.
IMPORTANT: Use ONLY the inlet hoses provided by KENMORE with this laundry product. Aftermarket hoses are not guaranteed to fit or function correctly. Other hoses may not tighten correctly and could cause leaks. Subsequent damage to product or property will not be covered under the terms of KENMORE's warranty.
Removing Lime Buildup
If you live in an area with hard water, lime scale can form on internal components of the washer.
Use of a water softener is recommended in areas with hard water. If a descaler is used, make sure that it is suitable for use in a washer, and run the CLEAN WASHER cycle before washing clothing.
Lime scale and other spots may be removed from the stainless steel tub using a stainless steel cleaner.
Do NOT use steel wool or abrasive cleansers; they can damage the surface.
Leave the Lid Open
It is recommended that you leave the lid open overnight after finishing the laundry.
24
!
Inlet Filter
Carefully remove the filters from the water inlets, and soak them in white vinegar or a lime scale remover.
Rinse thoroughly before reinstalling.
Press the filters back into place and reattach the water lines. Do NOT operate the washer without the inlet filters.
II