Kenmore 796.292796 manual Make sure that the water supply is turned on. Make sure

Page 29

II

BEFORE CALLING FOR SERVICE (cont.)

Washer won't

Control

panel is asleep

This is normal.

Press POWER.

operate

Washer

is unplugged

Make sure cord

is plugged securely into a working outlet.

Water supply is turned offTurn both hot and cold faucets fully on.

Controls are not set properlyMake sure the cycle was set correctly, close the lid and

press START.

Lid is open-safety feature prevents Close lid and reset cycle, to the beginning if necessary. the washer from filling and operation

when lid is up

Circuit breaker/fuse is tripped/blown Check house circuit breakers/fuses. Replace fuses or reset breaker. The washer should have a dedicated circuit.

Electronics need to be resetPress the POWER button, then reselect the desired cycle and press the START/PAUSE button.

START was not pressed after a Press the POWER button then reselect the desired cycle

cycle was set

and press the START/PAUSE button.

Extremely low water pressure Check another faucet in the house to make sure that household water pressure is adequate.

Washer is too cold

If the washer has been exposed to temperatures below

 

freezing for an extended period of time, allow it to warm up

 

before pressing POWER. Otherwise, the display will not

 

come on.

• Filter clogged or fill hoses may be

Washer not fillingkinked properly

• Energy efficiency

Make sure that filters (blue and orange screens must be free of solids) on the unit are not clogged. Refer to the filter cleaning instructions on page 24.

Check that fill hoses are not kinked or clogged.

This is an energy-efficient washer. As a result the tempera- ture settings for this washer may be different than non-energy-efficient washers.

• Insufficient

water supply

• Make sure that the water supply is turned on. Make sure

 

 

that the water faucets are turned to their completely open

 

 

positions.

• The washer

lid is open

• The washer lid must be closed for all washer cycle

 

 

operations. If the lid is opened during washer operation, all

 

 

functions will stop, including water filling.

• Incorrect fill hose connection

• Make sure that the fill hoses connect the hot water supply to

 

 

the hot inlet on the washer, and the cold water supply to the

 

 

cold inlet on the washer (hot to hot, cold to cold).

• Water fill optimization

• Water may not cover the top level of the clothes. This is

 

 

normal for this high-efficiency washer. The water fill is opti-

 

 

mized by the system for best wash performance.

29

II

Image 29
Contents Protocole P172 Protocol P172Coverage in Canada varies on some items Sears Installation ServiceMaster Protection Agreements Page Page To Connect Electricity KEY Parts and Components Choose the Proper Location KEY DiMENSiONSTools YOU will Need Unpacking the WasherExposedto freezing Connecting the Water LinesOption 1 Standpipe Connecting Drain LineConnect to the Power Supply Leveling the Washer Power ON/OFF Button Control Panel FeaturesCycle Modifier Buttons Time and Status DisplaySortlaundryand Load Washer Operating the WasherADD Detergent Begin CycleHeavy Duty Bulky Cycle GuideFabric Care Labels Sorting Wash LoadsGrouping Similar Items Loading the WasherFabric Softener Compartment About the DispenserMain Wash Detergent Compartment Liquid Bleach Compartment Detergent and Dispenser USE Using the Liquid Bleach DispenserWord About Detergents Riling the DispenserEstimated Time Remaining Cycle Status IndicatorTime and Status Display Soil Level Cycle Modifier ButtonsWater Temp Spin Speed Extra Rinse Stain TreatSave Energy Adda Garment Cycle Option ButtonsTo recall a my cycle To save a my cycleDrain & Spin Delay WashSpecial Safety Feature Care and Cleaning of the Interior Regular CleaningCleaning the Exterior Maintenance Regular CleaningCleaning the Water Inlet Filters Removing Lime BuildupProper Use of Detergent Cleaning the WasherCare and Cleaning of the Washer Water sloshing sound when tub is spinning Before Calling for ServiceNormal Sounds YOU MAY Hear ClickingII Ell Before Calling for ServiceBefore Calling for Service Make sure that the water supply is turned on. Make sure Is no higher than 96 above Kenmore Elite Limited Warranty Caracteristicas Acuerdos Maestros de ProteccionPage Page Para Conectar LA Electricidad Piezas Y Componentes Clave ASENTAiVllENTO EN EL Suelo ClaveDESEMBALAjE DE LA Lavadora Conexion DE LAS Ljneas DE Agua Opcion 1 Tubo vertical Conexion DE LA Manguera DE DesagueConectar AL Tomacorriente NotaNivelado DE LA Lavadora Caracteristicas DEL Panel DE Control Boton Power ON/OFF ENCENDIDO/APAGADOBaton DE INICIO/PAUSA Botones DE Programacion DE CiclosElija LA Ropa a Lavar Y LA CARGA. Consulte la pAgina Funcionamiento DE LA LAvADORAAnadir Detergente Encienda LA LavadoraAto Guja DE CiclosEtiquetas de cuidado de las telas Clasificacion DE LAS Cargas DE LavadoAgrupamiento de prendas similares PrecaucionCompartimiento principal del lavado con detergente Detalles Sobre EL DepositoCompartimiento de blanqueador liquido Compartimiento del suavizanteInformacion Sobre Detergentes USO DEL Detergente Y EL DispensadorComo Ilenar el distribuidor Uso de la lejia liquida en el dispensadorIndicador DE Estado DEL ClCLO LA Pantalla DE Tiempo Y EstadoTiempo Restante Estimado Water Temp Botones Modificadores DE CicloTemperatura Del agua Velocidad de centrifugadoBotones DE Opcion DE ClCLO Clean Washer Limpieza DE LA LavadoraExtra Rinse Enjuague Adicional Stain Treat Ttratamiento DE Mancha Water Plus MAS AguaPara acceder a un mi ciclo Akiadir UNA PrendaPara guardar un mi ciclo Fabric Softener SUA vlZANTEBotones DE Opcion DE Ciclo Delay WASh Retrasar LAvADOControl Lock Bloqueo DEL Control Drain & Spin Desaguar Y CentrifugarCuidado y limpieza del Interior Limpieza DEL ExteriorMantenimiento El almacenamiento de la lavadoraLimpieza de los filtros de entrada de agua Extraccion de acumulacion de calCuidado y limpieza de la lavadora Limpieza DE LA LavadoraAntes DE Solicitar Asistencia Ticnica Ruidos Normales QUE Puede EscucharAntes DE Solicitar Asistencia Tecnica TelAntes DE Solicitar Asistencia Ticnica ULJ HIlenado pueden Estar dobladas Uras Garantia Limitada de Kenmore Elite DE L1NSTALLATION Prototypedaccordde protection complementaireAvertissement Page Connexion Electrique Composants ET Piices Essentiels Prise DALIMENTATiON Spccifications ET Dimensions PrincipalesChoisir Lemplacement Approprii Outils Necessaires Diballer LE LAVE-LINGERaccordement DES Conduites Deau Option1 Tuyau de renvoi Raccordement DU Conduit DivacuationConnexion .A Lalimentation Remarque€leverAbaisser Boton DE ENCENDIDO/APAGADO Caractiristiques DU Panneau DE CommandeBouton Selecteur DE Cycle @ Boutons Doptions DE CycleElija LA Ropa a Lavar Y LA CARGA. Reportez-vous & la Funcionamiento DE LA LavadoraAjout DE Detergent Mise Sous Tension DE LA Machine a LaverGuide DE Cycle Tiquettesdentretien des tissus Triage DES BrasscesChargement de la machine a laver Groupement Dun e.le.ment similaireCompartiment a de.tergent de lavage principal Propos DU DistributeurCompartiment a assouplissant liquide Compartiment a javellisant liquideRemplissage du distributeur Detergemt AMD Dispenser USEUso de la lejia liquida en el dispensador Conqu PourRemarque Lccran DE Temps ET Dctat@ Temps Restant ESTIM¢ Timoin Lumineux DE Litatdu Cycle Soil Level niveau de salete Boutons DE Modification DU CycleWater Plus EAU Supplementaire Boutons Doptions DE CycleStain Treat Traitement DES Taches Pour utiliser un mon cycle ADD Garments Ajout DE LingeChime Carillon Pour enregistrer un mon cycleDrain & Spin Vidange ET Essorage Delay Wash Demarrage Differe Control LockEntretien et nettoyage de Iinte.rieur Nettoyage RigulierNettoyage de Iexterieur Entretien Entreposage du lave-lingeNettoyage des filtres darrivee deau £-Iimination des traces de calcaireUso correcto de los detergents Programme Avant DE Faire Appel AU Service APRIS-VENTEBruit declaboussure pendant que la cuve tourne QCH Avant DE Faire Appel AU Service APRIS-VENTE suiteH,= Avant DE Faire Appel AU Service APRIS-VENTE suite Ches Garantie limitee Kenmore Elite Manag