Instructions For Installing Loading Wheel
(Optional Accessory)
1.Locate the two
2.Bolt loading wheel to handle using the 5/16″ carriage bolts and lock nuts as shown in Figure 4.
NOTE! Loading wheel swivels up and down. Raise wheel for loading, lower wheel while transporting or operating machine.
Figure 4 – Loading Wheel
Instructions For Installing Lifting Hook
(Optional Accessory)
1.Locate the
2.Bolt lifting hook into place as shown in Figure 16.
Machine Inspection
WARNING
To prevent serious injury, inspect your Drain Cleaning Machine. The following inspection pro- cedures should be performed before each use.
1.Make sure the Drain Cleaning Machine is unplugged and the directional switch is set to the OFF position.
2.Make sure the foot switch is present and attached to
the Drain Cleaning Machine (Figure 5). Do not oper- ate the machine without a foot switch.
3.Inspect the power cord, Ground Fault Circuit Inter- rupter (GFCI) and plug for damage. If the plug has been modified, is missing the grounding prong or if the cord is damaged, do not use the Drain Cleaning Machine until the cord has been replaced.
Figure 5 – K-6200 Drain Cleaner
4.Inspect the Drain Cleaning Machine for any broken, missing, misaligned or binding parts as well as any other conditions which may affect the safe and normal operation of the machine. If any of these conditions are present, do not use the Drain Cleaning Machine until any problem has been repaired.
5.Lubricate the Drain Cleaning Machine, when nec- essary, according to the Maintenance Instructions.
6.Use tools and accessories that are designed for your drain cleaner and meet the needs of your application. The correct tools and accessories allow you to do the job successfully and safely. Accessories suitable for use with other equipment may be hazardous when used with this drain cleaner.
7.Clean any oil, grease or dirt from all equipment han- dles and controls. This reduces the risk of injury due to a tool or control slipping from your grip.
6 | Ridge Tool Company |