Kohler 1199249-2-A manual Care and Cleaning, Warranty, Maintaining the Airjets

Page 16

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER bath with airjets:

Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray that lands on nearby surfaces.

Do not allow cleaners to soak on surfaces.

Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.

The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface after each use.

Use a soft nylon brush on slip-resistant surfaces. Be sure to use a water-soluble cleaner (dissolves 100% in water).

Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances can block the airjets.

Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can damage the surface.

Do not use abrasive cleansers or solvents on airjet surfaces. Abrasive cleaners and solvents can damage the airjet surface.

Maintaining the Airjets

If cleaning the airjets is necessary due to hard water deposits, wet a soft, non-abrasive cloth with white vinegar and wipe the plugged airjet holes. Immediately rinse the area with clean water to avoid long-term exposure of the vinegar to the airjet surface.

Fill the bath with water to the top row of airjets. Drain the bath and press the purge button.

Cleaning Your User Keypad and Remote Control

Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a non-abrasive soap and warm water to clean.

For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care & Cleaning information, call 1-800-456-4537.

Warranty

Kohler Co. warrants the cast iron components of products manufactured after February 10, 2000, to be free of defects in material and workmanship during normal residential use for as long as the original consumer purchaser owns his or her home. Gloss reduction, scratching, staining and alkaline etching of the finish over time due to use, cleaning practices or water or atmospheric conditions, are not manufacturing defects but are indicative of normal wear and tear. This warranty applies only for KOHLER Cast Iron products installed in the United States of America, Canada or Mexico (North America).

If a defect is found in normal residential use, Kohler Co. will, at its election, repair, replace or make appropriate adjustment. Damage caused by accident, misuse, or abuse is not covered by this warranty. Improper care and cleaning will void the warranty. Proof of purchase (original sales receipt) must be provided to Kohler Co. with all warranty claims. Kohler Co. is not responsible for labor charges, installation, or other incidental or consequential costs. In no event shall the liability of Kohler Co. exceed the purchase price of the product.

If the cast iron product is used commercially or is installed outside of North America, Kohler Co. warrants the cast iron product to be free from defects in material and workmanship for one (1) year from the date the product is installed, with all other terms of this warranty applying except duration. All other components other than the enameled cast iron carry Kohler Co.’s one-year limited warranty unless otherwise specified.

If you believe that you have a warranty claim, contact Kohler Co., either through your Dealer, Plumbing Contractor, Home Center or E-tailer, or by writing: Kohler Co., Attn.: Customer Care Center, 444 Highland Drive, Kohler, WI 53044, USA. Please be sure to provide all pertinent information regarding your claim, including a complete description of the problem, the product, model number, color, finish, the date the product was purchased and from whom the product was purchased. Also include your original invoice. For other information, or to obtain the name and address of the service and repair facility nearest you call

1199249-2-A

16

Kohler Co.

Image 16
Contents Installation and Care Guide Electrical Requirements Product InformationProduct Notices Features Tools and MaterialsPrepare the Blower Remote Site Product InformationPrepare the Blower Remote Site Prepare the Site AlcoveInstall the Plumbing Install the BathCut the Banding Straps Typical Wiring Connection for North America Make Electrical Connections StandardRemove the Blower Motor and Check Valve Disconnect the Blower Motor RemotePrepare the Site Mount the Blower Motor and Check Valve Remote Manufacturer’s instructionsRoute the Power Cable Prepare the Blower for Remote InstallationConnect the New Power Cable at the Blower Motor Terminate the Cable at the Blower RemoteInstall the Blower Cord at the Control Remote Install the Second Junction Box on the ControlReconnect the Blower Motor Power Cord Reconnect the Blower New Power CableMake Power Connections Remote Complete the InstallationRemote Blower Test Run the BathComplete the Installation Finish the Installation Clean-up After InstallationImportant Safety Instructions Initiating a Manual Purge Cycle when desired Operating InstructionsStarting the Unit Selecting Air Flow ModesCare and Cleaning WarrantyCleaning Your User Keypad and Remote Control Maintaining the AirjetsWarranty For MexicoTroubleshooting Exceptions and RestrictionsTroubleshooting Symptoms Probable Causes Recommended ActionTroubleshooting Installations électriques requises Information sur le produitPréparer le souffleur Installation à distance Outils et matériauxCaractéristiques Information sur le produitPréparer le souffleur Installation à distance Alcôve Préparer le siteEncastrer par le dessus Installer la plomberie Installer la baignoireCouper les sangles de retenue Effectuer les connexions électriques Standard Câblage typique pour lAmérique du NordRetirer le moteur du souffleur et le clapet de non-retour Déconnecter le moteur du souffleur À distancePréparer le site Selon les instructions du fabricant Finir le câble au souffleur À distance Préparer le souffleur pour une Installation à distanceAcheminer le câble d’alimentation Finir le câble au souffleur À distance Installer le cordon au niveau de la commande À distance Installer le deuxième boîtier de jonction sur la commande60 Hz 50 Hz Depuis le contrôle Reconnecter le cordon d’alimentation du moteur du souffleurTerminer l’installation Effectuer les connexions électriques À distanceMoteur-souffleur à distance Tester le fonctionnement de la baignoireTerminer l’installation Nettoyer après l’installationInstructions Importantes sur la sécurité 1199249-2-A Français-14 Kohler CoInstructions d’utilisation Démarrer l’appareilSélectionner les modes de débit d’air Arrêter la baignoireMaintenance des jets d’air Nettoyer le clavier utilisateur et la télécommandeEntretien et nettoyage GarantieGarantie Limitée D’UN AN GarantieDépannage Symptômes Causes probables Action recommandée Dépannage1199249-2-A Français-20 Kohler Co Kohler Co Français-21 1199249-2-A Información sobre el producto Requisitos eléctricosHerramientas y materiales Prepare el soplador lugar remotoAvisos sobre el producto CaracterísticasPrepare el soplador lugar remoto Encajonado entre tres paredes Prepare el sitioDe sobreponer Corte las cintas Instale la bañeraInstale la plomería Realice las conexiones eléctricas Estándar Conexión de cableado típica para NorteaméricaRetire el motor soplador y la válvula de retención Desconecte el motor soplador RemotoPrepare el sitio Monte el motor soplador y la válvula de retención Remoto Del fabricanteTermine el cable en el soplador Remoto Tienda el cable eléctricoPrepare el soplador para la instalación remota Conecte el cable de eléctrico nuevo al motor sopladorTermine el cable en el soplador Remoto Instale el cable del soplador al control Remoto 60 Hz 50 Hz Del controlInstale la segunda caja de empalmes en el control Vuelva a conectar el cable eléctrico del motor sopladorRealice las conexiones eléctricas Remoto Termine la instalaciónSoplador remoto Pruebe el funcionamiento de la bañeraAcabe la instalación Termine la instalaciónLimpieza después de la instalación Instrucciones importantes de seguridad Kohler Co Español-14 1199249-2-AInstrucciones de funcionamiento Puesta en marcha de la unidadSelección de los modos de flujo de aire Pare el funcionamiento de la bañeraCuidado y limpieza GarantíaInstrucciones de funcionamiento Mantenimiento de los jets de aireGarantía Limitada DE UN AÑO GarantíaGuía para resolver problemas Para MéxicoGuía para resolver problemas Síntomas Causas probables Acción recomendadaKohler Co Español-20 1199249-2-A 1199249-2-A Español-21 Kohler Co 1199249-2-A Kohler Co